Weider 244 Bench Uk Manual - Page 6

ASSEMBLY Before beginning assembly, carefully read the following information and instructions: • Assembly requires two persons. • For help identifying small parts, use the PART IDENTIFICATION CHART on page 5. • Tighten all parts as you assemble them, unless instructed to do otherwise. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. The following tools (not included) are required for assembly: • Two adjustable spanners • One rubber mallet • One standard screwdriver • One Phillips screwdriver • Lubricant, such as grease or petroleum jelly, and soapy water. Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. 1. Before assembling this product, make sure that you have read and understand the information in the box above. Tap two 38mm Square Inner Caps (21) into the lower end of each Upright (1). Attach the Crossbar (3) to the two Uprights (1) with four M8 x 55mm Bolts (18), four M8 Washers (16), and four M8 Nylon Locknuts (17). Make sure that the Uprights and the Crossbar are oriented as shown. Do not tighten the Locknuts yet. 1 16 17 1 18 16 18 18 21 3 18 1 16 17 2. Tap three 38mm Square Inner Caps (21) into the Front Leg (8) and the Stabilizer (52). 2 Attach the Stabilizer (52) to the Front Leg (8) with two M8 x 50mm Carriage Bolts (49) and two M8 Nylon Locknuts (17). Do not tighten the Locknuts yet. Attach the Front Leg (8) to the Frame (2) with two M8 x 40mm Carriage Bolts (46), two M8 Washers (16), and two M8 Nylon Locknuts (17). Do not tighten the Locknuts yet. 21 46 21 2 16 8 16 17 17 21 49 17 52 21 6