Weider 950 English Manual - Page 7
Arm Assembly
View all Weider 950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ARM ASSEMBLY 5 5. Press two 25mm x 50mm Inner Cap (42) into the top of the Press Frame (9). Press two 50mm Square Inner Caps (44) into the ends of the Press Frame. Orient the Press Frame (9) with the bracket on the side shown. Attach the Press Frame to the Top Frame (5) with an M10 x 125mm Bolt (54), two M10 Washers (55), and an M10 Nylon Locknuts (56). 6. Press a 45mm Square Inner Cap (45) into the 6 end of the Right Arm (10). Press a 25mm Round Inner Cap (43) into the tube on the Arm. Wet the end of the Right Arm (10) with soapy water. Slide a Large Foam Pad (19) onto the Arm. Slide an Arm Grip (34) onto the handle on the Right Arm (10). Press a Dome Cap (47) into the end of the handle. Repeat this step with the Left Arm (not shown). 5 56 55 42 54 55 44 44 9 Bracket 45 10 43 Handle 34 47 19 7. Slide an Arm Bushing (46), with the lip on the bot- 7 tom, onto the post on the Right Arm (10). Insert the post through the hole in the Press Frame (9). Be sure the Arm is behind the indicated brack- 43 et on the Press Frame. 67 Slide a Large Washer (67) over the post on the Right Arm (10) and attach an M6 x 43mm Bolt (57) to it with an M6 Nylon Locknut (58). Be sure the Locknut and the head of the Bolt are over the edge of the Washer, as shown in the inset drawing. 46 Lip 58 Press a 25mm Round Inner Cap (43) into the top of the post on the Right Arm (10). Repeat this step with the Left Arm (11). 11 9 57 Bracket Post 10 Post 57 58 67 7