Weider Club 16.8st English Manual - Page 13

22. Remove the upper 3/8Ó x 3Ó Bolt (45) from the Top Frame (1) and the Main Upright (3). Feed the bolt on the High Cable (73) down through the indicated slot in the Main Upright (3) in the direction shown. Wrap the High Cable (73) around a 4Ó Pulley (35) in the direction shown. Attach the Pulley inside the slot in the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jam Nut (63). Re-insert the 3/8Ó x 3Ó Bolt (45) and secure it with a 3/8Ó Nylon Locknut (50). Note: The Cable (73) must be seated in the groove of the Pulley (35) before the Bolt is attached. 22 35 45 Slot 50 1 42 63 55 Bolt 3 55 54 42 73 23. Feed the bolt on the High Cable (73) under the welded tube on the Press Frame (12) as shown. Wrap the High Cable down around a 4Ó Pulley (35) in the direction shown. Attach the Pulley to the Press Frame (12) with a 3/8Ó x 8 1/2Ó Bolt (59) and a 3/8Ó Nylon Locknut (50). 23 Welded Tube 73 12 42 Wrap the High Cable (73) down around another 4Ó Pulley (35). Attach the Pulley inside the indicated slot in the Main Upright (3) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jam Nut (63). 42 35 63 55 55 50 Slot 54 55 59 35 Bolt 24. Wrap the High Cable (73) down around a 4Ó Pulley 24 (35) in the direction shown. Feed the bolt on the High Cable (73) back through the slot in the Main Upright (3) as shown. Attach the Pulley to the Press Frame (12) with a 3/8Ó x 8 1/2Ó Bolt (59) and a 3/8Ó Nylon 59 Locknut (50). Slot 73 50 Bolt 35 12 3 13