Weider Club 16.8st English Manual - Page 7
Carriage Bolt yet.
View all Weider Club 16.8st manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Place two Weight Bumpers (19) over the indicated holes in the Stabilizer (5). Insert the two Weight Guides (23) into the Weight Bumpers (19) and the Stabilizer (5). Attach the indicated Weight Guide (23) to the Stabilizer (5) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jam Nut (63). 4 23 19 63 55 42 5 19 55 42 54 5. See the inset drawing. Open the parts bag labeled ÒWeight InsertsÓ. Press two Weight Inserts (77) into the indicated holes in each Weight (26). Make sure the large pin groove is oriented as shown. Slide all nineteen Weights (26) onto the Weight Guides (23). Make sure the Weights are oriented correctly. The holes must be on the side shown. Slide the Top Weight (16) and the Weight Tube (36) onto the Weight Guides (23). Insert the Weight Tube into the Weights (26). Slide the welded tubes on the Top Frame (1) over the upper ends of the Weight Guides (23). Align the bracket on the Top Frame with the indicated holes in the Main Upright (3). Insert two 3/8Ó x 3Ó Bolts (45) into the holes. Thread a 3/8Ó Nylon Locknut (50) onto the lower Bolt. Do not thread a Locknut onto the upper Bolt yet. 5 50 1 50 Bracket 45 33 3 Welded 60 12 Tubes 23 16 36 77 Attach the Weight Guides (23) to the Top Frame (1) with two 3/8Ó x 1 3/4Ó Bolts (60) and two 3/8Ó Nylon Locknuts (50). Press two 2Ó Square Inner Caps (33) into the Press Frame (12). 26 Holes 26 Large Pin Groove 6. Slide the Leg Press Base (84) onto the 3/8Ó x 3 3/4Ó 6 Carriage Bolt (52) and the 3/8Ó x 5Ó Carriage Bolt (82) in the end of the Stabilizer (5). Tighten a 3/8Ó Nylon 50 Locknut (50) onto the 3/8Ó x 3 3/4Ó Carriage Bolt. Do not place a Nylon Locknut on the 3/8Ó x 5Ó Carriage Bolt yet. 5 84 82 52 7