Weider E5100 B Owners Manual - Page 9
Press, Assembly
View all Weider E5100 B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
WEIOER HEALTH and FITNESS STEP 6 ARM PRESS ASSEMBLY PART NAME OTY 60 1/4" X 1' FLAT HEAD MACHINE SCREW 2 63 1/4' X 1 3/4' CARRIAGE BOLT • 2 73 1/4' NYLON LOCK NUT 2 94 1114' ROUND PLASTIC CAP 4 93 ARM PRESS BUSHING 2 98 ARM PRESS SPACER 4 afr 93 93 PAGE 8 Press 1 1/4" ROUND PLASTIC CAPS (94) into each end of each ARM (23). If ARM PRESS SPACERS (98) have not been pre-assembled onto ARMS (23) then two each of these must be assembled onto the welded upright tube of the ARM (23). Slide each ARM (23) into the ARM PRESS ASSEMBLY (22) assembling them as a right and left. Secure each from the slot in the back of ARM PRESS ASSEMBLY (22) using 1/4" X 1" FLAT HEAD MACHINE SCREW (60). Make sure to completely tighten this bolt all the way In. See Detail "A". 22 22 60 42 98 94 73 25 63 23 Apply a small amount of liquid dish detergent onto ARMS (23) and slide on ARM PRESS PADS (24). These Pads will here be pushed around the curved part of the Arm and positioned above the elbow. The proper position of these Pads is dependent on the comfort of the person. Assemble an ARM PRESS STRAP BRACKET (25), curved side up, onto each ARM (23). Each Bracket should be assembled facing the back of the unit. Secure each with 1/4" X 1 3/4" CARRIAGE BOLT (63) and 1/4" NYLON LOCK NUT (73)• Remove ARM PRESS DECAL (42) from backing and adhere.it onto ARM PRESS ASSEMBLY (22) in position shown in illustration. Press the two sections of the ARM PRESS BUSHING (93) onto ARM PRESS ASSEMBLY (22) between the two large welded washers. These Bushing will not snap tight to the surface so they will have to be held tight as complete assembly is placed on the MAST TOP SECTION (1). DETAIL A 94 24