Weider Pro 350 L Bench English Manual - Page 7

3. Orient the Folding Lever (6) as shown, and insert it into the lower bracket on the Crossbar 3 (5). Attach the Folding Lever (6) to the Crossbar (5) with an M8 x 60mm Bolt (35) and an M8 Locknut (32). Do not overtighten the Locknut; the Folding Lever should pivot freely. Then, attach the Folding Lever (6) and the Spring (17) with an M8 x 45mm Bolt (43), an M8 Washer (30), and an M8 Locknut (32). Tighten the Locknut until three threads of the Bolt are below the Locknut. 32 43 6 17 30 5 32 35 4. Attach the Main Frame (7) to the Crossbar (5) with an M16 x 120mm Bolt (40) and an M16 4 Locknut (42). Do not overtighten the Locknut; the Main Frame should pivot freely. Attach the tether on the Pin (22) to the Crossbar (5) with an M4 x 16mm Screw (37). Then, insert the Pin (22) through the Crossbar (5) and the Main Frame (7). See steps 1 and 2. Tighten the M10 Locknuts (38) and the M8 Locknuts (32). 7 22 42 37 5 40 5. Orient the Leg Lever (11) and the Weight Tube (12) as shown. Attach the Weight Tube (12) to the Leg Lever (11) with an M8 x 55mm Bolt (31), two M8 Washers (30), a Weight Tube Bushing (29), and an M8 Locknut (32). Press the Bumper (25) onto the end of the Weight Tube (12). Apply some of the included grease to an M10 x 70mm Bolt (36). Attach the Leg Lever (11) to the Front Leg (10) with the M10 x 70mm Bolt (36) and an M10 Locknut (38). Do not overtighten the Locknut; the Leg Lever must pivot easily. 5 38 10 32 30 11 29 12 25 30 31 7 Grease 36