Weider Pro 408 English Manual - Page 10

Adjusting the Weight Bench This section explains how to adjust the weight bench. See the EXERCISE GUIDELINES on page 13 for important information on how to get the most benefit from your exercise program. Also, refer to the accompanying exercise poster to see the correct form for each exercise. Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents. FOLDING THE BACKREST To perform squat exercises, you will need to fold the Backrest (13) to the upright position. To fold the Backrest (13), lift and pull it forward as far as it 13 will go. It will be held in place by its own weight. WARNING: Always fold the backrest out of the way when performing squat exercises. Do not sit on the seat when the backrest is folded. MOVING THE ADJUSTMENT TUBE Remove the Adjustment Tube (12) by first rotating it until the locking clip (A) disengages the Left Upright (6). Then push the Adjustment Tube through the Right Upright (7), turn it at an angle and pull it out completely. 6 A 7 Insert the Adjustment Tube (12) by first pushing the end without the locking clip (A) into the Right Upright (7). Then push the other end into the Left Upright (6) as far as it will go. Rotate the Adjustment Tube until the locking clip 12 locks into place around the Left Upright. ADJUSTING THE BACKREST The Backrest (13) can be set to three different positions: a level position, a decline position and an incline position. To change the position of the Backrest (13), move the Adjustment Tube (12) to a different set of adjustment holes in the Uprights. When moving the Adjustment Tube (12), always make sure the locking clip (A) has snapped into place around the Upright. A 12 10