Weider Pro 9635 English Manual - Page 14
Locate the Low Cable 23. - cable routing
View all Weider Pro 9635 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
CABLE ASSEMBLY 25. Locate the Low Cable (23). Route the Low 25 Cable under the 3 1/2" Low Pulley (76) attached to the lower hole in the Press Frame (17). Be sure that the end of the Cable with the ball is on the indicated side of the Press Frame and that the Cable is between the Pulley and the crossbar on the Press Frame. Tighten the 3/8" Nylon Locknut (21) and the 3/8" x 3 3/4" Bolt (not shown). Crossbar 21 76 23 Ball 17 26. Route the Low Cable (23) around the 3 1/2" Pulley (15) attached to the lower hole in the Front Upright (42). See the inset drawing. Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8" Nylon Locknut (21) and the 3/8" x 3 3/4" Bolt (88). 26 21 42 15 23 15 88 66 42 Inset shows view from other side 23 27. Route the Low Cable (23) around the 3 1/2" Pulley (15) attached to the upper hole in the 27 Press Frame (17). Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the Cable is routed around the Pulley as shown. Tighten the 3/8" Nylon Locknut (21) and the 3/8" x 3 1/2" Bolt (not shown). 23 15 21 66 17 28. Route the Low Cable (23) around the 3 1/2" 28 Pulley (15) attached to the upper hole in the Front Upright (42). See the inset drawing. 23 Be sure that the Cable Trap (66) is turned to hold the Cable in place and that the 15 42 Cable is routed around the Pulley as shown. Tighten the 3/8" Nylon Locknut (21) 21 and the 3/8" x 3 3/4" Bolt (88). 23 15 88 66 42 Inset shows view from other side 14