Weslo Cadence 36 English Manual - Page 11
Time/distance Dis
View all Weslo Cadence 36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
1 Insert the key into the console. Inserting the key will not turn on the displays. The displays will turn on when the ON/ RESET button is pressed or when the walking belt is started. Note: If you just installed batteries, the displays will already be on. 2 Reset the speed control. Slide the speed control to the RESET position. Note: Each time the walking belt is stopped, the speed control must be moved to the RESET position before the walking belt can be restarted. 3 Start the walking belt. After you have moved the speed control to the RESET position, slowly slide it to the right until the walking belt begins to move at slow speed. Carefully step onto the walking belt and begin exercising. Change the speed of the walking belt as desired by sliding the speed control. To stop the walking belt, step onto the foot rails and slide the speed control to the RESET position. 4 Monitor your progress with the LCD displays. TIME/DISTANCE displayÑThis display shows the elapsed time and distance that you have walked or run, in miles. Every seven seconds, the display will change from one number to the other. Arrows in the display will show which number is currently shown. CALS/FAT CALS/ SPEED displayÑThis display shows the approximate numbers of calories and fat calories you have burned. (See FAT BURNING on page 22.) In addition, the display shows the speed of the walking belt, in miles per hour. Every seven seconds, the display will change. Arrows in the display will indicate which information is currently shown. To reset the displays at any time, press the ON/RESET button. 5 When you are finished exercising, stop the walking belt and remove the key. Step onto the foot rails, stop the walking belt, and remove the key from the console. The displays will turn off about five minutes after the key is removed. Note: Any time that the walking belt is stopped and the ON/RESET button is not pressed for five minutes, the displays will automatically turn off in order to conserve the batteries. HOW TO CHANGE THE INCLINE OF THE TREADMILL The incline of the treadmill can be changed by raising or lowering the back end. Before changing the incline, remove the key and unplug the power cord. Hold the rear roller endcap with both hands. When the back end of the treadmill is in the lowest position, Hold the Rear Roller Endcap in these locations Incline Leg the incline is about 10%. Raise the back end until it clicks into position. (Note: It may be necessary to shake the treadmill lightly so that it clicks into position.) The incline will then be about 7%. Raise the back end again until it clicks into posi- tion. The incline will then be about 3%. To lower the back end, raise it past the highest position and then lower it. CAUTION: Before exercising, push on the back of the treadmill to make sure that the incline legs are locked in position. Do not place objects under the treadmill to change the incline; change the incline only as described above. 11