Weslo Cadence 36 English Manual - Page 5
Save These Instructions
View all Weslo Cadence 36 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
the unit is in proper operating condition (refer to the drawing below). ¥ Use No. 10 AWG (5.3mm2) copper, No. 8 AWG (8.4mm2) aluminum, No. 17 AWG (1.0mm2) copper-clad steel or bronze wire, or larger as a ground wire. ¥ Secure antenna lead-in and ground wires to house with stand-off insulators spaced from 4 to 6 feet (1.22 to 1.83m) apart. ¥ Mount antenna discharge unit as close as possible to where the lead-in enters the house. ¥ Use jumper wire not smaller than No. 6 AWG (13.3mm2) copper, or the equivalent when a separate antenna-grounding electrode is used. See NEC Section 810-21 (j). Note to CATV system installer: This reminder is provided to call the CATV system installerÕs attention to Article 820-40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. Power Lines Service Entrance Conductors Service Entrance Equipment Power Service Grounding Electrode System (e.g. Interior Metal Water Pipe) Ground Clamp Standoff Insulators To External Antenna Terminal of Treadmill Ground Wire Mast Antenna Lead-in Wire Antenna Discharge Unit Ground Clamps Bonding Jumper Ground Wire Ground Clamps Optional Antenna Grounding Electrode Driven 8 Feet (2.44m) Into The Earth (If Required By Local Codes). See NEC Section 810Ð21 (f). SAVE THESE INSTRUCTIONS The decal shown below has been placed on your treadmill in the indicated location. If the decal is missing or illegible, please call our Customer Service Department, toll-free, at 1-800-999-3756 to order a free replacement decal. Apply the decal in the location shown. Note: The decal is shown at 38% of actual size. 5