Weslo Cadence 6.0 Treadmill Uk Manual - Page 9

7. Hold the Console (1) near the Console Base (100). Touch the Right Handrail (6) to discharge any static. Find the connector on the end of the Wire Harness (22). Insert the connector into the red socket beneath the Console. The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connector and then insert it. Make sure that the connector and wires appear as shown in drawing 7a. See drawing 5a. Insert the excess Wire Harness (22) down into the opening in the Console Base (100). Securely tighten the plastic tie on top of the Console Base to prevent the Wire Harness from slipping. Then, cut off the end of the plastic tie. 7 Ties 6 7a 22 1 100 22 8. Set the Console (1) on the Console Base (100). Insert the excess Wire Harness (22) into the large hole in the side of the Right Handrail (6). Securely tighten the plastic ties on the bottom of the Console Base to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties. Attach the Console (1) to the Console Base (100) with four 3/4" Screws (90) and two 1/2" Screws (84). Start all six Screws before tightening them; do not overtighten the Screws. 8 1 Ties 22 6 90 84 100 90 9. Attach the Latch Housing (41) to the Left Upright (88) with two 3/4" Screws (90). Remove the Latch Knob (95) from the Latch Pin (91). Make sure that the Latch Pin Collar (93) and the Spring (94) are on the Latch Pin as shown. Insert the Latch Pin into the Latch Housing (41), and tighten the Latch Knob onto the Latch Pin. Lift the treadmill frame to the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 14). Make sure that the frame is centered between the Handrails (not shown). Firmly tighten all of the bolts and screws used in assembly steps 3, 4, 5, and 8. Then, lower the frame to the floor. 9 41 95 90 88 Large Hole 94 93 91 10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keyes in a secure place. The large hex key is used to adjust the walking belt (see page 17). To protect the floor or carpet, place a mat under the treadmill. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. 9