Weslo Cadence 75 Treadmill Uk Manual - Page 6
Assembly
View all Weslo Cadence 75 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included hex keys and your own phillips screwdriver and needlenose pliers . , wire cutters For help identifying the assembly hardware, see the PART IDENTIFICATION CHART in the centre of this manual. Note: The assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so. 1. Make sure that the power cord is unplugged. Place the Base (79) in the position shown, with the indicated small holes on top (only one small hole is shown). Place a Wheel (63) in each Wheel Housing (62), and slide the Wheel Housings onto the ends of the Base that have bolt holes. Open part bag A. Attach the Wheels (63) to the Wheel Housings (62) with 2 1/2" Bolts (61) and Wheel Nuts (64). Make sure that the Wheel Nuts are on the sides shown; do not overtighten the Bolts. Slide the two Base Endcaps (75) onto the other ends of the Base (79) (only one Base Endcap is shown). Attach the four Base Pads (73) to the Base Endcaps and the Wheel Housings (62) with four 1 1/4" Tek Screws (60). 1 61 Bolt 73 Hole 60 73 75 60 63 62 79 64 60 64 63 73 62 61 Small Hole 2. Raise the Base (79) to a vertical position, and hold it near the treadmill Frame (96) as shown. Make sure that the Wheels (63) are in the indicated position. Identify the Right Upright (104), which has a large round hole in the indicated location. Feed the Wire Harness (65) into the hole and out of the top of the Right Upright. Make sure that there are two U-Nuts (74) in the lower end of the Right Upright (see drawing 2a). Hold the Right Upright against the Base (79) as shown. Make sure that the Right Upright is oriented so the pivot hole is in the position shown. Hand tighten two 3" Bolts (58) with two 5/16" Star Washers (57) into the bottom of the Base and the lower end of the Right Upright. Attach the Left Upright (47) to the Base (79) in the same way. Note: There is not a wire harness on the left side. With the help of a second person, raise the Uprights (47, 104) to a vertical position. 6 2 63 57 47 Pivot Holes 2a 104 74 58 79 104 96 63 58 57 Round Hole 65