Weslo Cadence 75 Treadmill Uk Manual - Page 8
Console May Be Damaged When The Power
View all Weslo Cadence 75 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
6. Attach the end of the ground wire to the small hole in the side of the right Handrail (40) with a Silver Ground Screw (66). Open part bag C. Attach the Crossbar (39) to the right Handrail (40) and the left Handrail (40) with two Crossbar Screws (37). Do not tighten the Crossbar Screws yet. Make sure that the rectangular hole in the Crossbar is on the indicated side. 6 40 Ground 66 Wire 37 40 Hole 39 37 7. Place the Console Base (67) on the right Handrail (40) and the left Handrail (not shown). Insert the Wire Harness (65) through the indicated nylon tie on the Console Base (67). Next, touch the right Handrail (40) to discharge any static. See drawing 7a. Find the connector on the end of the Wire Harness. Insert the connector into the red socket beneath the Console (69). The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connector and then insert it. IF THE CONNECTOR IS NOT INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Identify the 3/4" Screws (38); be careful not to confuse the 3/4" Screws with the 1/2" Screw (5). Attach the Console Base (67) to the right Handrail (40) and the left Handrail (not shown) with eight 3/4" Screws (only four Screws are shown). Start all eight Screws before tightening them. Do not overtighten the Screws. Tighten the Crossbar Screws (37). 8. Press the Wire Harness (65) into the recessed track on the back of the Console Base (67). Note: There may be a cylinder on the Wire Harness preventing it from being inserted into the track. Press as much wire as possible into the track. Insert the excess Wire Harness (65) into the large hole in the side of the right Handrail (40). Securely tighten the nylon tie to prevent the Wire Harness from slipping. Then, cut off the end of the nylon tie. Attach the Access Door (84) to the Console Base (67) with the 1/2" Screw (5). Tighten, but do not overtighten, the bolts used in step 5. With the help of a second person, lower the uprights and firmly tighten the bolts used in steps 2. 7 65 40 Tie 37 67 38 38 7a 69 65 8 40 67 65 84 5 Tie Track 9. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place. The large hex key is used to adjust the walking belt (see page 16). To protect the floor or carpet, place a mat under the treadmill. 8