Weslo Cadence Dl15 English Manual - Page 5
Assembly - parts
View all Weslo Cadence Dl15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small parts used in assembly. Assembly requires your own phillips screwdriver , two adjustable wrenches , and scissors . 1. Note that the Right Handrail and the Console Base 1 are connected to the treadmill by a Wire Harness (not shown). During steps 1 through 5, be careful not to pull on or damage the Wire Harness. With the help of a second person, carefully lay the treadmill on its side. Position one of the Base Legs 31 (38) on the base of the Upright (31) as shown. Make sure that the Base Leg Pads (41) and the Front Wheel (39) are in the indicated positions. Attach the Base Leg with two 3/8" x 2" Bolts (43), two 3/8" Washers (44), and two 3/8" Nuts (34). 39 34 43 44 41 38 Carefully turn the treadmill onto its other side. Assemble the other Base Leg (38) as described. With the help of a second person, carefully raise the 2 treadmill to the upright position so the Base Legs (38) are resting flat on the floor. 2. Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions in step 2 to lower the treadmill. Attach the Storage Latch (18) to the left Upright (31) with two Screws (24). Be careful not to overtighten the Screws. 31 24 18 3. Cut the plastic ties that hold the cage nuts in each Handrail (30, 32). 3 Position the Left Handrail (30) on the left Upright (31). Thread a 1/4" x 1" Bolt (23) with a 1/4" Washer (22) only two turns into the upper end of the left Upright and the Left Handrail. Do not tighten the Bolt yet. Thread a 1/4" x 1" Bolt (23) with a 1/4" Washer (22) only two turns into the lower end of the Left Handrail (30) and the left Upright (31). Do not tighten the Bolt yet. 23 22 30 31 22 23 5