Weslo Cadence Dl15 English Manual - Page 9
Note: Each - treadmill belt
View all Weslo Cadence Dl15 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
1 Insert the key fully into the power switch. Inserting the key will not turn on the display. The display will turn on when the ON/RESET button is pressed or when the walking belt is started. Note: If you just installed batteries, the display will already be on. 2 Reset the console and start the walking belt. Turn the speed control to the RESET position. Note: Each time the walking belt is stopped, the speed control must be turned to the RESET position before the walking belt can be restarted. Next, slowly turn the speed control until the walking belt begins to move at slow speed. Carefully step onto the walking belt and begin exercising. Change the speed of the walking belt as desired by turning the speed control. To stop the walking belt, step onto the foot rails and turn the speed control to the RESET position. • Calories (CALS)-This mode shows the approximate number of calories you have burned. If desired, reset the display by pressing the ON/RESET button. 4 When you are finished exercising, stop the walking belt and remove the key. Step onto the foot rails, stop the walking belt and remove the key from the console. The displays will turn off about six minutes after the key is removed. Note: The displays will automatically turn off in order to conserve the batteries any time that the walking belt is stopped and the ON/RESET button is not pressed for six minutes. HOW TO CHANGE THE INCLINE OF THE TREADMILL To vary the intensity of your exercise, the incline of the treadmill can be changed. There are three different incline levels. Before changing the incline, first remove the key and unplug the power cord. Next, fold the treadmill to the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 11). To change the incline, remove the incline pin from the right incline leg as shown below. Incline Pin 3 Follow your progress with the monitor modes When the power is turned on, the con- sole will automatically scan through five modes. A flashing mode indicator will show which mode is Mode Indicator currently displayed. The modes are described below. • Speed-This mode shows your speed, in miles per hour. Incline Pin Right Incline Leg Incline Pin Adjust the incline leg to the desired height and fully reinsert the incline pin. Make sure that the incline pin is in the "locked" position shown in the inset drawing. • Time-This mode shows the elapsed time. Note: If you stop exercising for ten seconds or longer, the time mode will pause. • Distance (DIST)-This mode shows the total number of miles you have walked or run. • Fat Calories (F CALS)-This mode shows the approximate number of fat calories you have burned. (See FAT BURNING on page 14.) Adjust the left incline leg in the same manner. Make sure that both incline pins are inserted from the direction shown. CAUTION: Before using the treadmill, make sure that both incline pins are fully inserted at the same height. Do not use the treadmill with the incline pins removed. After you have adjusted the incline legs, lower the treadmill (see HOW TO LOWER THE TREADMILL FOR USE on pages 11 and 12). 9