Weslo Cadence Dl15 English Manual - Page 6

4. With the help of a second person, hold the Console Base (12) and the Right Handrail (32) near the right Upright (31) as shown. Feed the excess Wire Harness (28) into the Handrail (32) and then insert it down the right Upright. Next, insert the bracket on the Right Handrail into the right Upright. Be careful not to pinch the Wire Harness. 4 12 Bracket 32 5. Thread a 1/4" x 1" Bolt (23) with a 1/4" Washer (22) only two turns into the upper end of the right Upright (31) and 5 the Right Handrail (32). Do not tighten the Bolt yet. Thread a 1/4" x 1" Bolt (23) with a 1/4" Washer (22) only two turns into the lower end of the Right Handrail (32) 32 and the right Upright (31). Do not tighten the Bolt yet. 28 31 23 22 31 6. Set the Console Base (12) on the Handrails (30, 32). Make sure that the Wire Harness (28) is out of the way as you loosely thread four 1 1/4" Screws (24) into the Handrails and the Console Base. Next, push the Wire Harness down the right Upright (31). It may be necessary to pull the Wire Harness out the bottom of the right Upright. Tighten all parts used in steps 3 and 5. Then, tighten the 1 1/4" Screws (24) used in this step. 7. Remove the six Weight Rack Screws (97) from the right Upright (31). Attach a Weight Rack (74) to the right Upright with the Weight Rack Screws. Attach the other Weight Rack to the left Upright (not shown) in the same way. Put the two 2-lb. Weights (20) on the upper hooks on the Weight Racks (74), the 3-lb. Weights (19) on the center hooks, and the 4-lb. Weights (17) on the lower hooks. 6 28 32 23 22 12 24 30 31 7 97 31 74 24 20 19 17 8. Remove the backing from the Wrench Clip (91). Press the Wrench Clip onto the base of the right Upright (31) in 8 the indicated location. Press the Allen Wrench (90) into the Wrench Clip. 9. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill. 6 31 90 91