Weslo Daybreak 408 Spa English Manual - Page 15
Spa See Attaching And Removing
View all Weslo Daybreak 408 Spa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
4. Remove the drainage hose from the spa and attach a garden hose to the valve on the drainage hose. 5. Open the valve by turning the knob counterclockwise. The water will begin to drain. 6. When the spa is empty, close the valve and remove the garden hose. Return the drainage hose to the clip and replace the access cover. 7. Refill the spa and treat the water with chemicals (see pages 10 and 14). Pump Motor Drain Hose Cap Valve Knob DRAINING THE PUMP After the hydrotherapy spa is drained (see DRAINING THE HYDROTHERAPY SPA on page 14), the pump should also be drained if the hydro- therapy spa will be stored for more than Drain Plug thirty days, or if it may be exposed to freezing temperatures. Pump To drain the pump, remove the access cover from the spa (see ATTACHING AND REMOVING THE ACCESS COVER on page 14). Locate the pump inside the spa unit. Remove the drain plug from the pump and allow all water to drain from the pump. Replace the drain plug. WINTER USE AND CARE The hydrotherapy spa is designed for year-round use. If you decide to store the spa for the winter, store it in a warm, dry location. Follow the steps below to winterize the spa. 1. Drain the spa (see DRAINING THE HYDROTHERAPY SPA on the previous page and this page). 2. Remove all remaining water from the spa shell. Dry the spa shell with towels. 3. Set the air control on the console to the lowest setting. Use a wet/dry vacuum to pull any remaining water from the system. To do this, place the vacuum nozzle over each jet, starting with the highest jet and finishing with the lowest one. 4. Set the air control on the console to the highest setting and repeat step 3. 5. Drain the pump (see DRAINING THE PUMP on this page). Once the water has drained from the pump, place the vacuum nozzle over the drainage hole in the pump and vacuum any additional water from the pump. Note: For additional protection, remove the pump/motor from the spa and store it in a climate-controlled room. 6. Clean the spa shell (see page 13). 7. Clean the filter (see page 13). 8. A qualified electrician should disconnect the power cord from the 240-volt power source, if so wired. 9. Re-attach the access cover and re-attach the spa cover. 15