Weslo Daybreak 408 Spa English Manual - Page 8

Assembly Before beginning assembly, carefully read the following information and instructions: • Place all parts in a cleared area and remove the packing materials from the spa shell. Do not dispose of the packing materials until assembly is completed and the spa is in operation. • During assembly, make sure that all parts are oriented as shown in the drawings. • Read each assembly step before you begin. • Tighten all parts as you assemble them, unless instructed to do otherwise. ASSEMBLY REQUIRES THE FOLLOWING TOOLS (not included): • One (1) phillips screwdriver • You may also need some soap or water A wire connector is provided on the pump motor of the hydrotherapy spa to connect a minimum No. 8 AWG (804 mm2) solid copper conductor between the spa and any metal equipment, electrical enclosure made of metal, metal water pipes, or conduit within five feet of the spa. This unit is a cord-connected spa with pump, 1 heater, and spa side controls. 1. Before beginning assembly, make sure that you have read and understand the information in the box above and on the previous two pages. Remove the four #6 x 1 1/4" Wood Screws (7) from the Access Cover (2). Remove the Access Cover from the spa by sliding the Access Cover down and then pulling the bottom of it away from the spa. Make sure you don't damage the spa shell. Remove the power cord with the GFCI from inside the spa. Access Cover (2) #6 x 1 1/4" Wood Screws (7) Power Cord with (GFCI) 2. Close the valve knob on the drain hose. Thread the cap onto the drain hose. Thread the Drain Plug into the Pump Motor. Tighten the pump fittings. Re-attach the Access Cover (2) with the four #6 x 1 1/4" Wood Screws (7) removed in step 1. 2 Drain Plug Cap Valve Knob 8 Pump Fittings Pump Motor Drain Hose