Weslo Pro 13.8e Elliptical Canadian English Manual - Page 10

9. Tighten an M8 x 25mm Patch Screw (22) and an M8 Large Washer (53) into each end of the Pivot 9 Axle (97). Attach the Axle Caps (23) by pressing the small tabs into the Upper Body Arm Spacers (25). 97 22 53 23 25 23 53 22 25 10. Apply grease to the barrel of an M10 x 55mm Bolt Set (27) and to the two Leg Bushings (28) 10 in the left Upper Body Leg (79). 79 Attach the left Upper Body Leg (79) to the Left 79 Pedal Arm (14) with the M10 x 55mm Bolt Set (27). Do not overtighten the Bolt Set; the left Grease Upper Body Leg must pivot freely. 103 28 27 28 Attach the right Upper Body Leg (79) to the Right Pedal Arm (103) in the same way. Grease See step 3. Tighten the M10 x 88mm Button Screws (63). See step 7. Tighten the M8 x 45mm Button Bolts (50) in the Upper Body Legs (79). 27 14 11. Attach a Pedal Bracket (16) to the Left Pedal Arm (14) with two M8 x 65mm Button Screws (99), two M8 Large Washers (53), and two M8 Locknuts (46). Identify the Left Pedal (13), which is marked with a "Left" sticker. Attach the Left Pedal to the Left Pedal Arm (14) with two M8 x 50mm Button Screws (89), two M8 Split Washers (100), and two M8 Large Washers (53). Attach the other Pedal Bracket (not shown) and the Right Pedal (12) to the Right Pedal Arm (103) in the same way. 11 103 12 46 14 53 16 99 53 100 89 13 53 12. Make sure that all parts are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 10