Weslo Summit St100 English Manual - Page 5
ArmBushings
View all Weslo Summit St100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
5. Slide a Pedal Arm Spacer (10) onto the lower right pedal axle on the Upright (6). Make sure that the open side of the Pedal Arm Spacer is turned toward the Upright. Apply 10 grease to the lower pedal axles. Make sure that there are two Pedal ArmBushings (11) in each side of the Right Pedal 6 Arm (15), and one Link Arm Bushing (26) in the Link Arm (21). Slide the Right Pedal Arm (15) and Link Arm (21) onto the pedal axles as shown. Tap a Push Cap (28) onto the upper pedal axle, and an Axle Cap (29) onto the lower pedal axle. Attach the Left Pedal Arm and Link Arm (not shown) in the same manner. 6. Rest the Pedal Arms (15, 16) on the brackets at the lower ends of the Resistance Cylinders (20). Make sure that the brackets are fully inserted into the same slots under both Pedal Arms. Pedal Axles 26 21 I 11 28 15 11 9 16 20 20 0 15 7. Connect the Sensor Wire (3) to the wire extending from the Console (1) (see the inset drawing). Insert all excess wire into the Upright (6). Attach the Console to the plate at the top of the Upright with four Screws (2). Attach the Accessory Tray (32) to the Console. See page 7 for battery installation instructions. Batteries are not included. 14 32 0 3 \