Whirlpool GU3200XTXY Installation Instructions - Page 15

2 Insert plastic buttons plastic button Push the plastic buttons out of the side of the tub. NOTE: Save the buttons to cover the holes after dishwasher is installed. 3 Reinstall bracket bend tabs Push bracket into slot on the side of dishwasher, and bend tab in toward the side of the dishwasher so that it keeps the bracket in place. Repeat this step for the other side of the dishwasher. NOTE: Do not attach the dishwasher. This will be done later. Move Dishwasher into Cabinet Opening Excessive Weight Hazard Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury. 1 Stand dishwasher upright 2 Move dishwasher close to cabinet opening Water line Drain hose Cable Direct wire only IMPORTANT: Double-check correct placement of utilities. Grasp the sides of the dishwasher at the edges of the door panel. Tilt dishwasher backward on wheels and move dishwasher close to cabinet opening. NOTE: Do not push on the front of the panel or on the console. Panel or console may dent. Helpful Tip: Temporarily tape utilities to the floor in the locations shown to keep them from moving when dishwasher is moved into the cabinet opening. 3 Check water and drain hose position Check that water line is on the left side of opening and drain hose is near the center of the cabinet opening. 4 Open and close door Using two or more people, stand dishwasher upright. NOTE: Do not install kick plate until instructed to do so. With another person holding the dishwasher to keep it from tipping, open and close the door a few times. If the door closes or falls open under its own weight, the door tension will need to be adjusted. 15