Whirlpool GU3200XTXY Installation Instructions - Page 17
Connect to Water Supply, Connect to Drain
UPC - 883049201979
View all Whirlpool GU3200XTXY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
10 Check level side to side and adjust legs if needed Connect to Drain 1 Loop drain hose drain loop Place level against top front opening of tub. Check that dishwasher is level from side to side. If dishwasher is not level, adjust front legs up or down until dishwasher is level. Connect to Water Supply 1 Tighten 90° elbow fitting to valve Be sure rubber washer is properly seated in fitting. Slide the ³⁄₄" fitting up to the valve and hand tighten to avoid cross-threading. Hand tighten until the coupling is tight. Using pliers, check the tightness of the coupling. An additional ¹⁄₄ to ¹⁄₂ turn may be required to seal the rubber gasket. NOTE: Do not overtighten. Damage to the coupling can result. 2 Check for leaks To help minimize vibration, route drain hose to avoid contact with motor, door springs, water line, cabinet, flooring or the edge of the hole where it passes through the cabinet. Do not remove drain loop from side of dishwasher. Place pan under end of drain hose. Pan will collect any water in drain hose. 2 Connect drain hose Green clamp Black drain hose connector Drain hose Stop Drain hose stop Stop Place towel under drain hose to catch any water in drain hose. Place the small green drain hose clamp onto the small end of the drain hose. Push the new drain hose into the black drain hose connector up to the drain hose stop. 3 Slide clamp onto connector Green clamp Black drain hose connector Stop Drain hose Drain hose stop Stop Place paper towel under 90° elbow fitting. Turn on water supply and check for leaks. If leak occurs, repeat previous step. If needed, see website for animated representation of this step. Visit www.whirlpool.com/watersupply under FAQ tab. Using pliers, squeeze open the small green drain hose clamp and slide onto connector between stops. 17