Whirlpool W5CG3024XS Installation Instructions - Page 11
Complete Installation - lowes
UPC - 883049225630
View all Whirlpool W5CG3024XS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Complete Installation Electronic Ignition System Check Flame Height Adjust the height of surface burner flames. Initial lighting and gas flame adjustments Surface burners use electronic igniters in place of standing pilots. When the cooktop control knob is turned to the "IGNITE" position, the system creates a spark to light the burner. This sparking continues, as long as the control knob is turned to "IGNITE." The surface burner "low" flame should be a steady blue flame approximately ¼" (0.64 cm) high. A Check Operation of Surface Burners Push in and turn the surface burners control knobs to light. The surface burner flame should light within 4 seconds. The first time a surface burner is lighted it may take longer that 4 seconds to light because of air in the gas line. Check the flame on "HIGH" for a blue color. It should be clean and soft in character. No yellow tip, blowing or lifting of flame should occur. Occasional orange flashes are normal and reflect different elements in the air or gas. After verifying the proper burner operation, turn the control knobs to "OFF." If burners do not light properly: ■ Turn surface burner control knob to the "OFF" position. ■ Check that the power supply cord is plugged in and the circuit breaker has not tripped or the fuse blown. ■ Check that the gas shutoff valves are set to the "open" position. ■ Check that burner caps are properly positioned on burner bases. Recheck operation of surface burners. If a burner does not light at this point, contact your dealer or authorized service company for assistance. B A. Low flame B. High flame If the "low" flame needs to be adjusted: 1. Light 1 burner and turn to lowest setting. 2. Remove the control knob. 3. Hold the knob stem in the low position using a pair of pliers. Use an ¹⁄₈" (3.0 mm) flat-blade screwdriver to turn the screw located in the center of the control knob stem until the flame is the proper size. 4. Replace the control knob. 5. Test the flame by turning the control from "LO" to "HI," checking the flame at each setting. 6. Repeat above steps for each burner. 11