Whirlpool WDT730HAM Cycle Guide - Page 2

Option Guide Options: Descriptions: High (Hi) Temp Heat Dry 4 Hour (Hr) Delay Raises the main wash temperature to improve cleaning for loads containing tough, bakedon food. Dries dishes with heat. This option, with the use of rinse aid, will provide better drying performance. Plastic items are less likely to deform when loaded in the top rack. Turn the Heat Dry option off for an air dry. Runs dishwasher at a later time. Select a wash cycle and options. Select 4 Hr Delay. Select Start/ Resume. Close door firmly. NOTE: Anytime door is opened (such as, to add a dish), Start/ Resume must be selected again to resume delay countdown. Can Be Selected With: Heavy Normal Heavy Normal Available with any cycle What It Does: Raises the main wash temperature up to 135°F (57°C). Uses a heating element to speed drying times. Delays the start of a cycle to the specified duration. Added Time to Cycle (Hr:Min): 0:35-0:45 0:52 4:00 Added Water Gallons (Liters): 0-3.7 (0-14.0) 0 0 Control Lock (Hold 3 Sec) Sani Rinse Use the Control Lock option to avoid unintended use of dishwasher between cycles or cycle and option changes during a cycle. To turn on Control Lock, press and hold 4 Hour Delay for 3 seconds. Control Lock light will stay on for a short time, indicating that it is activated. When the Lock indicator is lit, all buttons are disabled. If you press any button while your dishwasher is locked, the light flashes three times. The dishwasher door can still be opened/closed while the controls are locked. To turn off Control Lock, press and hold 4 Hour Delay for 3 seconds. Control Lock light turns off. On some models, to active the Control Lock, press and hold the Sani Rinse button for 3 seconds to lock. Sanitizes dishes and glassware in accordance with NSF International NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments. Only sanitizing cycles have been designed to meet the requirements of the NSF/ ANSI 184 performance standard for soil removal and for sanitization efficacy. There is no intention, either directly or indirectly, that all cycles on a NSF/ ANSI 184 certified dishwasher meet the NSF/ANSI 184 performance standard for soil removal and for sanitization efficacy. The Sani Rinse indicator glows at the end of the cycle if the Sani Rinse option was successfully completed. If the indicator does not activate, it is probably due to the cycle being interrupted. Sensor Heavy Normal Raises the main wash temperature to 130°F (54°C) and the final rinse temperature to 155°F (68°C). 1:00-1:30 0-2.6 (0-10.0) 2