Whirlpool WFW5620HW Owners Manual - Page 51

TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Solution Error Code Appears in Display (for 2- and 3-digit displays) (cont.) "rL" (remove load) appears in display Load detected in drum during Clean Remove items from washer drum and restart Clean Washer Washer with affresh cycle. with affresh cycle. F# E# or F## E## code other than as described above appears in display System error code. Touch POWER once to clear the code. Then touch POWER again to restart washer. If code appears again, call for service. Unplug washer for 30 seconds; then plug back in. Washer making error beeps Door has not been opened and closed for at least three cycles. This code may occur when the washer is first turned on. Open and close the door to clear the display. Washer beeps when Start/ Door not closed. Pause is touched Close the door completely. Clean Washer LED flashing at end of wash cycle (on some models) The washer has run 30 wash cycles and is indicating a reminder to run the Clean Washer with affresh cycle. Run the Clean Washer with affresh cycle. If the Clean Washer with affresh cycle is not turned on, the LED will stop flashing at the end of a wash cycle after running three more regular wash cycles. After 30 more wash cycles are completed, the Clean Washer with affresh LED will again flash at the end of a wash cycle as a reminder. 51