Whirlpool WFW5620HW Owners Manual - Page 58
Control Lock is On.
View all Whirlpool WFW5620HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
TROUBLESHOOTING First try the solutions suggested here or visit our website at www.whirlpool.com.tw. If you experience Possible Causes Washer Not Performing As Expected (cont.) Gray whites, dingy colors Load not sorted properly. Wash temperatures too low. Incorrect dispenser operation Not enough detergent used, or hard water. Clogged dispensers or laundry products dispensing too soon. Single-dose laundry packet not dissolving Cycle time changes or cycle time too long Liquid chlorine bleach not used in bleach compartment. Water in dispenser after cycle has finished. Adding laundry packet incorrectly. Normal washer operation. Excessive suds in washer. Load may be out of balance. Not using correct cycle for load type. The controls are not responding Control Lock is On. Solution The transfer of dye can occur when mixing whites and colors in a load. Sort dark clothes from whites and lights. Use hot or warm temperatures if safe for the load. Make sure your hot water system is adequate to provide a hot water wash. Use more detergent for washing heavy soils in cold or hard water. Do not overfill dispenser. Overfilling causes immediate dispensing. Load dispensers before starting a cycle. Homes with low water pressure may result in residual powder in the dispenser. To avoid, select a warmer wash temperature if possible, depending on your load. Use only liquid chlorine bleach in the bleach compartment. It is normal for small amounts of water to remain in dispenser at the end of the cycle. Be sure laundry packet is added to washer drum before adding clothes. Do not add packet to dispenser. Follow the manufacturer's instructions to avoid damage to your garments. The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The options you select will also affect the cycle times. When excessive suds are detected, a special suds routine automatically starts to remove extra suds and ensure proper rinsing of your garments. This routine will add time to the original cycle. When load unbalance occurs, a washing process will start to redistribute the load. This extends the cycle time. Avoid washing single items. Balance a single item such as a rug or jeans jacket with a few extra items. The Quick Wash cycle is designed for smaller load sizes (2-4 items) of lightly soiled garments. If larger loads are washed in this cycle, cycle time will be increased. When using the Quick Wash or Delicates cycle, you should wash small loads. This ensures a gentle wash for your garments without increasing cycle time. Touch and hold CONTROL LOCK for 3 seconds to turn off Control Lock. For each second Control Lock is held down, the display will count down one second: you will see "3," then "2," then "1." 58