Whirlpool WFW9470WW Owners Manual - Page 7
Installation Instructions - washer
UPC - 883049186856
View all Whirlpool WFW9470WW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
■ Do not have a fuse in the neutral or ground circuit. 2. Once the bolt is loose, move it to the center of the hole and completely pull out the bolt, including the plastic spacer covering the bolt. 3. Once all 4 bolts are removed discard bolt and spacers. Then pull the power cord through the opening of the rear panel and close the hole with the attached cap. 4. Close the bolt holes with the 4 transport bolt hole plugs. NOTE: If the washer is to be transported at a later date, call your local service center. To avoid suspension and structural damage to your washer, it must be properly set up for relocation by a certified technician. Connect the Inlet Hoses 1. Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings. INSTALLATION INSTRUCTIONS Remove Transport System WARNING Excessive Weight Hazard Use two or more people to move and install washer. Failure to do so can result in back or other injury. IMPORTANT: Position the washer so that the rear of the washer is within approximately 3 ft (900 mm) of its final location. There are 4 bolts in the rear panel of the washer that support the suspension system during transportation. These bolts also retain the power cord inside the washer until the bolts are removed. A B A. Coupling B. Washer 2. Make sure the washer drum is empty. 3. Attach the hose with the red color indicator to the Hot (left) inlet valve. Attaching the red coupling first makes it easier to tighten connection with pliers. Screw on coupling by hand until it is seated on the washer. 4. Attach the hose with the blue color indicator to the Cold (right) water inlet valve. Screw on coupling by hand until it is seated on the washer. H C 1. Using a 13 mm wrench, loosen each of the bolts. H. Hot water inlet C. Cold water inlet 5. Using pliers, check the tightness of the hose couplings already attached to the washer. NOTE: Do not overtighten. Damage to the coupling can result. 6. Attach hot water hose to the hot water faucet. Screw on coupling by hand until it is seated on the washer. 7. Attach cold water hose to the cold water faucet. Screw on coupling by hand until it is seated on the washer. 7
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48