Whirlpool WGD5800S Installation Instructions - Page 3
ExplosionHazard, flammable, materials - dryer
View all Whirlpool WGD5800S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Installation Clearances The location must be large enough to allow the dryer door to open fully. Dryer Dimensions \ 151A'' (38.74crn) 22¾" ExplosionHazard Keepflammablme aterialasnd vapors, such as gasoine, away from dryer. Place dryer at least 18 inches (48 cm) above the floor for a garage installation. Failure to do so can resumt in death, explosion, or fire. (66cm) J x You will need • A location that allows for proper exhaust installation. A gas dryer must be exhausted to the outdoors. See "Venting Requirements." • A grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See "Electrical Requirements." • A sturdy floor to support the dryer and a total weight (dryer and load) of 200 Ibs (90.7 kg). The combined weight of a companion appliance should also be considered. • A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet kit, Part No. 279810.) Clothes may not tumble properly and models with automatic sensor cycles may not operate correctly if dryer is not level. Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector. NOTE: No other fuel-burning appliance can be installed in the same closet as a dryer. (110crn) C D A. Small Opening Side-Swing Door B. Large Opening Side-Swing Door C. Wide Opening Side-Swing Door D. Wide Opening Hamper Door *Most installations require a minimum 5V2" (14 cm) clearance behind the dryer for the exhaust vent with elbow. See "Venting Requirements." Minimum installation spacing for recessed area or closet installation The dimensions shown following are for the minimum spacing allowed. • Additional spacing should be considered for ease of installation and servicing. • Additional clearances might be required for wall, door and floor moldings.