Whirlpool WML55011HS Installation Instructions
Whirlpool WML55011HS Manual
 |
View all Whirlpool WML55011HS manuals
Add to My Manuals
Save this manual to your list of manuals |
Whirlpool WML55011HS manual content summary:
- Whirlpool WML55011HS | Installation Instructions - Page 1
to Wall 9 Install the Microwave Oven 9 Complete Installation 10 VENTING DESIGN SPECIFICATIONS 11 ASSISTANCE 12 Replacement Parts 12 MICROWAVE HOOD COMBINATION SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on - Whirlpool WML55011HS | Installation Instructions - Page 2
for wall or roof venting. See the "Venting Design Specifications" section. Location Requirements IMPORTANT: Check the opening where the microwave oven will be installed. The location must provide: ■■ Minimum installation dimensions. See the "Installation Dimensions" illustration. ■■ Minimum one - Whirlpool WML55011HS | Installation Instructions - Page 3
understood, or if doubt exists as to whether the microwave oven is properly grounded. Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. SAVE THESE INSTRUCTIONS 10 " 26.2cm 10 " 26.2cm 45.51c8m - Whirlpool WML55011HS | Installation Instructions - Page 4
INSTALLATION INSTRUCTIONS The Microwave oven is set for recirculation installation. For wall or roof venting, changes must be made to the venting system. NOTE: Skip below sections if you are using recirculation installations. Go to section "Locate Wall Stud(s)". Keep the damper assembly in case the - Whirlpool WML55011HS | Installation Instructions - Page 5
good performance of airflow, for Wall and Roof venting, remove the charcoal filter from the bottom plate before operating the microwave oven. Charcoal Filter Grease Filter Vent Cover Installation (for both wall and upper vent installation) 1. Remove screws attaching B and C cover. Slide them out - Whirlpool WML55011HS | Installation Instructions - Page 6
Wall Stud Configurations These depictions show examples of preferred installation configurations with the mounting plate. No Wall Studs at the vertical centerline (see "Mark Rear Wall" section), only recirculation or roof venting installation can be done. Wall Studs at End Holes Figure 3 B D A - Whirlpool WML55011HS | Installation Instructions - Page 7
washers used to secure the microwave oven to the upper cabinet. NOTE: If replacing a range hood that has the direct wire power supply coming from the wall, install outlet box accessory kit in upper cabinet. The Outlet Box Kit (part #W11082816) is not provided but can be purchased from Whirlpool. 7 - Whirlpool WML55011HS | Installation Instructions - Page 8
A C B 4 Corners REAR WALL REAR WALL Mark Rear Wall The microwave oven must be installed on a minimum of 1 wall stud, preferably 2, using a minimum of edge of cabinet D. Front edge of upper cabinet Wall Venting Installation Only 4. If venting through the wall, place mounting plate on the wall and - Whirlpool WML55011HS | Installation Instructions - Page 9
Wall Stud(s)" section. For fast wall and roof vent installation, see the quick reference guide on the mounting plate. No Wall Studs at End "Installation for Wall Stud at One End Hole" in the "Drill Holes in Rear Wall" section. 3. Using 2 or more people, lift microwave oven and hang it on support - Whirlpool WML55011HS | Installation Instructions - Page 10
space between the upper cabinet bottom and the microwave oven. 11. Connect vent to damper assembly. A B A. Vent B. Damper assembly (under vent) Compact A Complete Installation 1. Install filters. Refer to the User Instructions for filter placement. WARNING A. Bolts NOTE: Avoid damage to the - Whirlpool WML55011HS | Installation Instructions - Page 11
clearance within the wall for the damper to open fully. If venting through the roof, and rectangular-to-round transition is used, be sure there are at least 3" (7.6 cm) of clearance between the top of the microwave oven and the transition piece. See "Rectangular-to-Round Transition" illustration - Whirlpool WML55011HS | Installation Instructions - Page 12
a rectangular 3" (7.6 cm) extension vent between the damper assembly and rectangular to round transition piece must be installed to keep the damper from sticking. ASSISTANCE Call your authorized dealer or service center. When you call, you will need the microwave oven model number and serial number
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
-
9
-
10
-
11
-
12
 |
 |
MICROWAVE HOOD COMBINATION
INSTALLATION INSTRUCTIONS
This product is suitable for use above electric or gas cooking products up to and including 36" (91.4 cm) wide. See the “Installation
Requirements” section for further notes.
These installation instructions cover different models. The appearance of your particular model may differ slightly from the illustration
in these installation instructions.
Table of Contents
MICROWAVE HOOD COMBINATION SAFETY
W11359126A
MICROWAVE HOOD COMBINATION SAFETY
............................
1
INSTALLATION REQUIREMENTS
.................................................
2
Tools and Parts
.............................................................................
2
Location Requirements
................................................................
2
Product Dimensions
.....................................................................
3
Electrical Requirements
...............................................................
3
INSTALLATION INSTRUCTIONS
...................................................
4
Wall Venting Installation Only
.......................................................
4
Install Damper Assembly (for wall venting only)
..........................
4
Roof Venting Installation Only
......................................................
4
Install Damper Assembly (for roof venting only)
..........................
5
Locate Wall Stud(s)
......................................................................
5
Prepare Upper Cabinet
................................................................
7
Mark Rear Wall
.............................................................................
8
Drill Holes in Rear Wall
.................................................................
8
Attach Mounting Plate to Wall
.....................................................
9
Install the Microwave Oven
..........................................................
9
Complete Installation
.................................................................
10
VENTING DESIGN SPECIFICATIONS
.........................................
11
ASSISTANCE
................................................................................
12
Replacement Parts
.....................................................................
12
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING