Whirlpool WML55011HS Installation Instructions - Page 4

INSTALLATION INSTRUCTIONS The Microwave oven is set for recirculation installation. For wall or roof venting, changes must be made to the venting system. NOTE: Skip below sections if you are using recirculation installations. Go to section "Locate Wall Stud(s)". Keep the damper assembly in case the venting method is changed or the microwave oven is reinstalled in another location where wall or roof venting may be used. Install Damper Assembly (for wall venting only) 1. Check that damper blade moves freely, and opens fully. 2. Position the damper assembly on the back of the microwave oven so that the damper blade hinge is at the top, and the damper blade opens away from the microwave oven. A BC D Wall Venting Installation Only 1. Using diagonal wire cutting pliers, gently snip out the rectangular vent cover on the damper plate. A B A. Diagonal wire cutting pliers B. Damper vent covers A. Back of microwave oven B. Damper assembly C. Damper blade D. Sheet metal screw 5/32" x 5/16" (4 mm x 8 mm) 3. Secure damper assembly with two sheet metal screws 5/32" x 5/16" (4 mm x 8 mm). Roof Venting Installation Only 1. Remove screws attaching damper plate to top of microwave oven exterior. Slide damper plate toward the front of the microwave oven and lift up. A B A. Screws B. Damper plate 4