Whirlpool WRF560SFYB Use & Care Guide - Page 10

Replacing the Air Filter The disposable air filter should be replaced every 6 months, or when the status indicator air filter icon turns on and starts flashing when the refrigerator door is opened. To order a replacement air filter, contact us. See "Accessories." 1. Remove the used air filter by squeezing in on the side tabs. 2. Install the new air filter and reset the status indicator using the instructions in the previous section. Install Produce Preserver (on some models) The accessory packet includes two produce preserver pouches, which should be installed in a crisper drawer prior to use. NOTE: For best performance, always use two pouches. The produce preserver absorbs ethylene, to slow the ripening process of many produce items. As a result, certain produce items will stay fresh longer. Ethylene production and sensitivity varies depending on the type of fruit or vegetable. To preserve freshness, it is best to separate produce with sensitivity to ethylene from fruits that produce moderate to high amounts of ethylene. Produces Ethylene Very Low Low Sensitivity to Ethylene High Very High High Broccoli Lettuce Spinach Apples Pears Med. Asparagus Citrus fruit Cantaloupe Low Carrots Berries Grapes Installing the Produce Preserver CAUTION: IRRITANT MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES FORM WHEN MIXED WITH OTHER PRODUCTS. Do not mix with cleaning products containing ammonia, bleach or acids. Do not get in eyes, on skin or clothing. Do not breathe dust. Keep out of reach of children. FIRST AID TREATMENT: Contains potassium permanganate. If swallowed, call a Poison Control Center or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, rinse with water. The produce preserver pouches should be installed in the housing, located on the wall of one of the crisper drawers. 1. Remove the FreshFlow™ Produce Preserver pouches from the packaging. 2. Lift up on the housing to remove it from the mounting tab. 3. Open the housing by pulling up and out on the back of the top of the housing. 4. Place both pouches inside the housing, then snap the housing back together. 5. Place the housing back on the mounting tab. Installing the Status Indicator The produce preserver comes with a status indicator, which should be activated and installed at the same time the pouches are installed. REPLACE MONTHS 1. Place the indicator face-down on a firm, flat surface. 2. Apply pressure to the bubble on the back of the indicator until the bubble pops, to activate the indicator. 3. Slide open the cap on the top of the produce preserver housing. 4. Place the indicator in the top of the housing, facing outward. 5. Slide the cap closed, and check that the indicator is visible through the rectangular hole in the cap. NOTE: The cap will not easily close if the indicator's bubble has not been popped. Replacing the Produce Preserver The disposable pouches should be replaced every 6 months, when the status indicator has completely changed from white to red. To order replacements, contact us. See "Accessories" for information on ordering. 1. Remove the used pouches from the produce preserver housing. 2. Remove the used status indicator. 3. Install the replacement pouches and status indicator using the instructions in the previous sections. CAUTION IRRITANT Read cautions on back. ATTENTION IRRITANT prudences sur Lisez des l e revers. 10