Xerox 750DP DocuColor Server User Guide - Page 19
Restarting the DocuColor
![]() |
UPC - 042215455107
View all Xerox 750DP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
11-7 Starting and shutting down the DocuColor When the diagnostics are finished, the following message is displayed: For software update or setup press any key If you want to change the Setup options, press one of the buttons; if you do not press a button, the DocuColor continues starting up and displays the message Idle when it is ready to receive data. If you press a button, the following options appear: Choose: To do this: Run Setup View the options in the Setup menus. For information on these settings, see the Administrator Guide. Install Software Install new system software. This should be done only by your DocuColor service representative. Format Disk Reformat the DocuColor hard disk. This should be done only by your DocuColor service representative. Restarting the DocuColor You should use the procedure described in this section to restart the DocuColor rather than using the power switch on the rear of the DocuColor. TO RESTART THE DOCUCOLOR: 1. Make sure that the DocuColor is not receiving, processing, or printing a document. Make sure that the status message on the Control Panel is Idle. NOTE: If a job from the Print Queue is processing, it will continue processing and print after the DocuColor is restarted; if a job sent to the direct connection is processing, it will not finish processing or printing. 2. Press the Menu button to display the Functions menu. 3. Use the down arrow button to scroll to the last screen and choose Reboot Server.
![](/manual_guide/products/xerox-750dp-docucolor-server-user-guide-e052851/19.png)