Xerox 750DX Fiery SI Color Server User Guide - Page 23
Restarting the FierySI
UPC - 042215455060
View all Xerox 750DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
11-8 Operating the Fiery SI If you press a button, the following options appear: Choose: To do this: Run Setup View the options in the Setup menus. For information on these settings, see the Administrator Guide. Install Software Install new system software. This should be done only by your Fiery SI service representative. Format Disk Reformat the Fiery SI hard disk. This should be done only by your Fiery SI service representative. Restarting the Fiery SI You should use the procedure described in this section to restart the Fiery SI rather than using the power switch on the rear of the Fiery SI. TO RESTART THE FIERY SI: 1. Make sure that the Fiery SI is not receiving, processing, or printing a document. Make sure that the status message on the Control Panel is Idle. NOTE: If a job from the Print Queue is processing, it will continue processing and print after the Fiery SI is restarted; if a job sent to the direct connection is processing, it will not finish processing or printing. 2. Press the Menu button to display the Functions menu. 3. Use the down arrow button to scroll to the last screen and choose Reboot Server.