Xerox 790N Fiery SI Color Server Administration Guide - Page 24
Parallel cable connection, Getting Started, User Guide
![]() |
UPC - 042215474368
View all Xerox 790N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
11-13 Parallel cable connection TO USE THICKNET CABLE: 1. With the Fiery SI turned off, connect the thicknet cable connector to the AUI connector on the back of the Fiery SI. Press down on the latch to lock the connector. 2. Configure network servers for printing and then proceed to Setup. TO USE TWISTED PAIR CABLE: 1. With the Fiery SI turned off, connect the RJ-45 cable connector to the RJ-45 socket on the back of the Fiery SI. 2. Configure network servers for printing and then proceed to Setup. Parallel cable connection In addition to receiving print jobs over Ethernet, the Fiery SI can accept print jobs from a PC-compatible computer or server through its high-speed parallel port. This connection is advantageous for portable computers and for workstations that use dedicated networks using protocols other than AppleTalk, TCP/IP, or IPX. The parallel port connection is active at the same time as the Ethernet port. TO USE PARALLEL CABLE: 1. With the Fiery SI and a PC-compatible computer or server turned off, attach the Centronics-type parallel cable to the parallel port of the Fiery SI. The parallel port is the top connector on the back of the Fiery SI. 2. Connect the other end of the cable to the parallel port on the PC. 3. Turn on the computer and the Fiery SI. 4. Proceed to Setup. To print to the parallel port, you will need to set up the parallel port connection. See "Parallel Port Setup options" on page 2-20. For information on setting up printing, see Getting Started; for printing to the parallel port, see the User Guide.
![](/manual_guide/products/xerox-750dp-fiery-si-color-server-administration-guide-5bc20ba/24.png)