Yamaha 2100E Owners Manual - Page 31

Setup Procedures @ After the computer's operating system (Windows 95/98/98 Second Edition) has loaded, open the "Control Panel" and double-click on the "System" icon. Select the "Device Manager" tab and doubleclick on "CDROM." If the drive has been correctly installed, it should be listed as shown below. Similarly, double-click on "SCSI controllers" and the SCSI card should be listed as shown below if it has been properly installed. n For details about how to use the operating system, refer to the documentation that came with it. n If there is a or mark etc. next to the icon for the CRW2100S drive or the SCSI card, this means that it has not been installed correctly. n When using Windows NT, you can verify by opening the "Control Panel," double-clicking on "SCSI Adapter" and clicking the "Devices" tab. n For Windows 2000, double-click "System" in the "Control Panel," select the "Hardware" tab, and click the "Device Manager" button in "System Properties." * This is a screen shown in the Windows 98 Second Edition environment. # Double-click "YAMAHA CRW2100S" listed under "CDROM" (in Windows 95/98/98 Second Edition) and click the "Settings" tab. Check the "Sync data transfer" checkbox. With "Sync data transfer" enabled, the data transfer between your CRW2100S drive and your computer is synchronized, meaning that the maximum possible data transfer rate can be achieved. n For details, refer to the documentation that came with your SCSI card. n When using Windows NT/2000, "Sync data transfer" will automatically be selected if the SCSI card supports this feature. You will not need to change this setting. * This is a screen shown in the Windows 98 Second Edition environment. $ Install the CD writing software. n For details about how to install the software, refer to the documentation that came with it. 22