Yamaha 505 Owner's Manual - Page 114
CVP-503: Keyboard Stand Assembly
View all Yamaha 505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
3 CVP-503: Keyboard Stand Assembly CAUTION • Assemble the stand on a hard and flat floor with ample space. • Be careful not to confuse parts, and be sure to install all parts in the correct direc- tion. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver of the appropriate size ready. 1 Open the package, take out marked "C" in the illustration, take out the styrofoam pads, and place the unit A on top of the pads. Position the pads so that they will protect the headphone jack located underneath the front left corner. CAUTION To prevent the key cover from accidentally opening during assembly, press down on the key cover, making sure that the sheet (shown) remains in place. Main unit A Phones jacks Styrofoam pads Back panel B Bundled pedal cord inside Pedal box C Side panel (left) D E Side panel (right) Assembly Parts 6 x 25 mm long screws x 4 6 x 16 mm short screws x 4 AC power cord 4 x 20 mm tapping screws x 4 Cord holders x 2 4 x 12 mm thin screws x 2 2 Attach C to D and E. 1 Untie and straighten out the bundled cord attached to the bottom of the C. Don't discard the vinyl tie, you'll need it later in step 6. D E C 2 Use the four 6 x 25 mm long screws to attach C. First attach one side panel, then attach the other side panel. 3 Attach B. Depending on the model of digital piano you purchased, the surface color of one side of the rear panel may be different from the other side. In this case, position the rear panel so that the side of the surface color similar to the side panel (left) and the side panel (right) faces the player. 1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2 Attach the top of B to D and E by finger-tightening the thin screws (4 x 12mm). 3 While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws (4 x 20mm). 4 Insert the other two tapping screws (4 x 20mm) into the other two screw holes to secure B. 5 Securely tighten the screws on the top of B that were attached in Step 3- 2). 1 E 25 4 Mount A. B 3 4 D 3 CAUTION • Fingers can become pinched between A and C/D/E, be extra careful so as not to drop A. • Do not hold the keyboard in any position other than the position shown in the illustration. Be sure to place your hands at least 10 cm from either end of A when positioning it. A At least 10 cm CVP-503: Keyboard Stand Assembly 114 CVP-509/505/503/501 Owner's Manual