Yamaha 505 Owner's Manual - Page 116
CVP-501: Keyboard Stand Assembly
View all Yamaha 505 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
3 CVP-501: Keyboard Stand Assembly CAUTION • Assemble the stand on a hard and flat floor with ample space. • Be careful not to confuse parts, and be sure to install all parts in the correct direc- tion. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver of the appropriate size ready. 2 Attach (finger-tighten) C to D and E. 1 Untie and straighten out the bundled pedal cord. Don't discard the vinyl tie, you'll need it later in step 7. 2 Align D and E with each end of C. 3 Attach D and E to C by finger-tightening the long screws (6 x 20 mm). E 2 1 Open the package, take out marked "C" in the illustration, take out the styrofoam pads, and place the unit A on top of the pads. Remove all parts from the box. Confirm that all parts shown in the illustration are provided. Main unit A Styrofoam pads Back panel B Bundled pedal cord inside Pedal box C Side panel (left) D E Side panel (right) Assembly Parts 6 x 20 mm long screws x 4 6 x 16 mm short screws x 4 4 x 12 mm thin screws x 2 AC power cord 4 x 20 mm tapping screws x 4 Cord holders x 2 C D 3 1 L 3 Attach B. Depending on the model of digital piano you purchased, the surface color of one side of the rear panel may be different from the other side. In this case, position the rear panel so that the side of the surface color similar to the side panel (left) and the side panel (right) faces the player. 1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2 Attach the top of B to D and E by finger-tightening the thin screws (4 x 12mm). 3 While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws (4 x 20mm). 4 Insert the other two tapping screws (4 x 20mm) into the other two screw holes to secure B. 5 Securely tighten the screws on the top of B that were attached in Step 3- 2). 1 E 25 B 3 4 3D 4 Securely tighten the screws on C that were attached in Step 2-3. C Tighten the screws. CVP-501: Keyboard Stand Assembly 116 CVP-509/505/503/501 Owner's Manual