Yamaha 6FX Owner's Manual - Page 24
C-R OUT Jacks, SEND Jacks, RETURN L MONO, R Jacks, REC OUT L, R Jacks, 2TR IN Jacks, POWER Switch,
View all Yamaha 6FX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Front & Rear Panels 6 C-R OUT Jacks These are impedance-balanced phone-type output jacks. These jacks output the mixed signal whose level is adjusted by the C-R/PHONES control. Output is in stereo (L and R). These jacks are typically used to connect to a monitor system. NOTE The signal monitored by these jacks is selected by the Level-Meter Signal switches and the channel PFL switches. 7 SEND Jacks • AUX1, AUX2 These are impedance-balanced phone-type output jacks. These jacks output the signal from AUX1 and AUX2, respectively. You use these jacks, for example, to connect to an effector or to a cue box or other such monitoring system. • EFFECT This is an impedance-balanced phone-type output jack that outputs the signal from the EFFECT bus. You use this jack, for example, to connect to an external effector. 8 RETURN L (MONO), R Jacks These are unbalanced phone-type input jacks. The signal received by these jacks is sent to the Stereo bus and the AUX1 and AUX2 buses. These jacks are typically used to receive a return signal from an external effector (reverb, delay, etc.). NOTE These jacks can also be used as an auxiliary stereo input. If you connect to the L(MONO) jack only, the mixer will recognize the signal as monaural and will propagate the identical signal on both L and R jacks. 9 REC OUT (L, R) Jacks These are unbalanced RCA-pin-type output jacks. By connecting these jacks to an external recorder, you can record the same signal that is being output from the ST OUT jacks. NOTE The mixer's ST Master Fader does not operate on the signal output from these jacks. Be sure to make appropriate level adjustments at the external recording device. 0 2TR IN Jacks These unbalanced RCA-pin-type input jacks are used to input a stereo sound source. Use these jacks when you want to connect a stereo sound sources (CD or DAT) directly to the mixer for monitoring. NOTE You can adjust the signal level using the 2TR IN control in the Master Control section. A POWER Switch Use this switch to set the mixer power to ON or STANDBY. Note that trace current continues to flow while the switch is in the STANDBY position. If you do not plan to use the mixer again for a long while, be sure to unplug the adaptor from the wall outlet. B AC ADAPTOR IN Connector Connects to the included PA-30 power adaptor (see page 5). Use only the PA-30 adaptor included with this mixer. Use of a different adaptor may result in fire or electric shock. Connector Polarities MIC INPUT, ST OUT LINE INPUT (monaural channels), GROUP OUT, ST OUT, C-R OUT, AUX1, AUX2, EFFECT* INSERT I/O PHONES Pin 1: Ground Pin 2: Hot (+) Pin 3: Cold (-) Tip: Hot (+) Ring: Cold (-) Sleeve: Ground Tip: Output Ring: Input Sleeve: Ground Tip: L Ring: R Sleeve: Ground INPUT OUTPUT Ring Sleeve Tip RETURN, LINE INPUT (stereo channels) Tip: Hot Sleeve: Ground Sleeve Tip * These jacks will also accept connection to monaural phone plugs. If you use monaural plugs, the connection will be unbalanced. 24 MG16/6FX