Yamaha CLP-811 Owner's Manual - Page 55

(52)~(68) Organ Combination data 2 (69)~(85) Organ Combination data 3 (86)~(102) Organ Combination data 4 (103)~(119) Organ Combination data 5 (120)~(136) Organ Combination data 6 (137)~(153) Organ Combination data 7 (154)~(170) Organ Combination data 8 * The Clavinova does not accept requests to transfer panel data. 7. System Exclusive Messages (Universal System Exclusives) 1) Universal Realtime Message [F0H] → [7FH] → [XnH]→ [04H]→ [01H] → [RRH] → [mmH] → [F7H] MIDI Master Volume * This message changes the volume for all channels at the same time. * Receipt of this message affects the volume on the MIDI receiving channel(s) only. Panel volume does not change. F0H: Exclusive status 7FH: Universal realtime 7FH: ID of target device 04H: Sub-ID #1 (Device control message) 01H: Sub-ID #2 (Master Volume) RRH: Volume LSB mmH: Volume MSB F7H: End of Exclusive -orF0H: Exclusive status 7FH: Universal realtime XnH: X is ignored; n=0~F 04H: Sub-ID #1 (Device control message) 01H: Sub-ID #2 (Master Volume) RRH: Volume LSB mmH: Volume MSB F7H: End of Exclusive 2) Universal Non-Realtime Message (GM ON) [F0H] → [7EH] → [XnH]→ [09H]→ [01H] → [F7H] GM (General MIDI) Mode ON F0H: Exclusive status 7EH: Universal non-realtime 7FH: ID of target device 09H: Sub-ID #1 (General MIDI message) 01H: Sub-ID #2 (General MIDI ON) F7H: End of Exclusive -orF0H: Exclusive status 7EH: Universal non-realtime XnH: X is ignored; n=0~F 09H: Sub-ID #1 (General MIDI message) 01H: Sub-ID #2 (General MIDI ON) F7H: End of Exclusive * Receipt of the GM ON message causes MIDI parameters to reinitialize. Allow sufficient time for processing to execute (about 50 msec) before sending the Clavinova another message. 8. System Exclusive Messages (XG Standard) 1) XG Native Parameter Change [F0H] → [43H] → [1nH]→ [4CH]→ [hhH] → [mmH] → [RRH] → [ddH] ... → [F7H] F0H: Exclusive status 43H: Yamaha 1nH: Device No. (If transmission, n=0. If reception, n=0~F.) 4CH: XG model ID hhH: Address High mmH: Address Mid RRH: Address Low ddH: Data : : F7H: End Of Exclusive 2) Bulk Dump (Receive only) [F0H] → [43H] → [0nH]→ [4CH] → [aaH] → [bbH] → [hhH] → [mmH] → [RRH] → [ddH] → ... → [ccH] → [F7H] F0H: Exclusive status 43H: Yamaha 0nH: Device No. (n=0~F.) 4CH: XG model ID aaH: Byte count bbH: Byte count hhH: Address High mmH: Address Mid RRH: Address Low ddH: Data : : ccH: Checksum F7H: End Of Exclusive * Receipt of this message causes reinitialization of relevant parameters and Control Change values. Allow sufficient time for processing to execute (about 50 msec) before sending the Clavinova another message. * XG Native Parameter Change message may contain two or four bytes of parameter data (depending on the parameter size). * For information about the Address and Byte Count values, refer to Table 1 below. Note that the table's Total Size value gives the size of a bulk block. Only the top address of the block (00H, 00H, 00H) is valid as a bulk data address. * Transmission of excessive bulk-data length may cause error at the receiving side. Keep message length within 512 bytes. If you need to send more than 512 bytes, break the transmission into multiple parts and allow at least 120 msec between each transmission. MIDI Parameter Change (SYSTEM) Address (H) Size (H) 00 00 00 4 01 02 03 Data (H) 020C~05F4 04 1 05 1 06 1 7E 7F Total Size 7 00~7F 34~4C 0 0 Parameter MASTER TUNING MASTER VOLUME Description -50~+50 [cents] 1st byte bits (3~0) → Bits 15~12 2nd byte bits (3~0) → Bits 11-8 3rd byte bits (3~0) → Bits 7-4 4th byte bits (3~0) → Bits 3-0 0~127 Default (H) 00 04 00 00 400 7F TRANSPOSE -12~+12 [semitones] 40 XG SYSTEM ON 00=XG System ON RESET ALL PARAMETERS 00= ON (Receive only) * Value below 020CH selects -50 cents. Value above 05F4H selects +50 cent. * Values 28H to 33H select -12 to -1, respectively. Values 4DH to 58H select +1 to +12, respectively. MIDI Parameter Change (EFFECT 1) * For a listing of REVERB, CHORUS, and VARIATION type numbers, refer to the Effect MIDI maps. Address (H) Size (H) 02 01 00 2 0C 1 Data (H) 00~7F 00~7F 00~7F Parameter REVERB TYPE MSB REVERB TYPE LSB REVERB RETURN Description Default (H) Refer to the Effect MIDI Map. 01 (=HALL 1) 00: Basic Type 00 -∞dB...0dB...+6dB (0...64...127) 40 02 01 40 2 00~7F 00~07F VARIATION TYPE MSB Refer to the Effect MIDI Map. VARIATION TYPE LSB 00: Basic Type 00 (No effect) 00 Note: "VARIATION TYPE" corresponds to the Clavinova's panel-set effect type. MIDI Parameter Change (Multipart) Address (H) Size (H) 08 nn 11 1 nn= Part number Data (H) 00~7F Parameter DRY LEVEL Description 0~127 Default (H) 7F CLP-811/611 MIDI Data Format/MIDI-Datenformat/Format de données MIDI/Formato de datos MIDI 51