Yamaha DSP-E800 Owner's Manual - Page 22

DIGITAL SOUND FIELD PROCESSOR (DSP) EFFECT Selecting a DSP Program You can enhance your listening experience by selecting a DSP program. Refer to pages 22 to 24 for details about each program. NATURAL SOUND AV PROCESSOR/AMPLIFIER DSP-E800 CINEMA DSP DOLBY D I G I TA L D I G I TA L SURROUND INPUT SELECTOR STANDBY/ON - SET MENU + NEXT TAPE/MD MON /6CH INPUT EFFECT PROGRAM INPUT MODE VOLUME 16 20 12 28 8 40 4 60 00 -dB 2 0 2 POWER PROGRAM /DTS MOVIE MOVIE SUR. THTR 1 THTR 2 21 2 3 MONO MOVIE TV SPORTS DISCO 4 5 6 ROCK HALL 7 8 TEST EFFECT DSP TIME/LEVEL SET MENU 6CH INPUT CD TUNER TAPE/MD 1 Make sure that the effect speakers (center and rear) and subwoofer are turned on. 2 Press PROGRAM l or h repeatedly (or one of the PROGRAM selector buttons) to select the desired program. The name of the selected program appears on the display. PROGRAM /DTS MOVIE MOVIE SUR. THTR 1 THTR 2 1 2 3 PROGRAM or MONO MOVIE TV SPORTS DISCO 4 5 6 ROCK HALL 7 8 Front panel Remote control Notes • You can select a DSP program for each of the input sources. Once you select a program, it is linked with the input source selected at that time. So, when you select the input source next time, the same program is automatically selected. • When a monaural source is being played with PRO LOGIC/ Normal or PRO LOGIC/ENHANCED, no sound will be heard from the main speakers and the rear speakers. Sound can only be heard from the center speaker. However, if "CENTER SP" on the SET MENU is set to the NONE position, the center channel sound is output from the main speakers. • When a source connected to the 6CH INPUT terminals of this unit is selected, the digital sound field processor cannot be used. • When high-rate 96-kHz sampling 24-bit digital signals are input to this unit, no DSP program can be selected and the sound is only output from right and left main speakers as a normal 2-channel stereo sound. Canceling the Sound Effect (turning off the effect speakers) Press EFFECT to cancel the sound effect and monitor only the main sound. Press EFFECT again to turn the sound effect back on. EFFECT or EFFECT Front panel Remote control Notes • If you turn off the sound effect when Dolby Digital or DTS is decoding, the sounds of the center and rear channels are mixed and output from the main speakers. • If you turn off the sound effect when Dolby Digital or DTS is decoding, it may happen that the sound is output faintly or not output normally, depending on the source. In this case, turn sound effect back on. PRO LOGIC DSP MOVIE THEATER 2 DVD/LD D-TV VCR TUNER CD CBL/SAT DSP program name y If desired, adjust the delay time and the sound output level of each speaker. (Refer to pages 29 and 30 for details.) E-20