Yamaha EMX512SC Owner's Manual - Page 33

Specifications Power Consumption AC Cord Dimensions Net Weight EMX512SC EMX312SC EMX212S Length Height Depth Width MIN 2450 TYP 500 450 300 2500 284 264 442.5 8 MAX 2550 UNIT W mm mm kg Included Accessories Power cord, Rubber stabilizers × 2, Owner's Manual Options RACK MOUNT KIT (RK512), FOOT SW (FC5) Note: All level control normally: Maximum level, Output impedance of signal generator :150 ohm ■ Input Characteristics Input Terminals Actual MIC/LINE Load Impedance For Use with Nominal Input Level Sensitivity *2 Nominal (▼ position) Max. before Clip Connector CH INPUT 1-4 MIC XLR LINE Phone MIC LINE 2 kΩ 50-600 Ω Mics 6 kΩ 600 Ω Lines -60 dBu (0.775 mV) -30 dBu (24.5 mV) -50 dBu (2.45 mV) -20 dBu (77.5 mV) -35 dBu (13.8 mV) -5 dBu (436 mV) -25 dBu (43.6 mV) +5 dBu (1.38 V) -15 dBu (138 mV) +15 dBu (4.36 V) -5 dBu (436 mV) +25 dBu (13.8 V) XLR-3-31 type *3 Phone Jack *4 CH INPUT 5/6, 7/8 XLR - Phone - 2 kΩ 10 kΩ 50-600 Ω Mics 600 Ω Lines -60 dBu (0.775 mV) -20 dBu (77.5 mV) -35 dBu (13.8 mV) +5 dBu (1.38 V) -15 dBu (138 mV) +25 dBu (13.8 V) XLR-3-31 type *3 Phone Jack *5 CH INPUT 9/10, 11/12 XLR - Pin - 2 kΩ 10 kΩ 50-600 Ω Mics 600 Ω Lines -60 dBu (0.775 mV) -20 dBu (77.5 mV) -35 dBu (13.8 mV) +5 dBu (1.38 V) -15 dBu (138 mV) +25 dBu (13.8 V) XLR-3-31 type *3 RCA Pin Jack *1 0 dBu is referenced to 0.775 Vrms. *2 Sensitivity is the lowest level that will produce an output of +4 dB (1.23 V), or the nominal output level when the unit is set to maximum level. (All level controls are at maximum position.) *3 XLR-3-31 type connectors are balanced. (1=GND, 2=HOT, 3=COLD) *4 Phone Jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND) *5 Phone Jacks are unbalanced. ■ Output Characteristics Output Terminals Actual Source Impedance For Use with Nominal SPEAKERS [A1, A2, B1, B2] 0.1 Ω 4 Ω Speakers EMX512SC EMX312SC EMX212S MAIN OUT [L, R] 600 Ω 10 kΩ Lines - EFFECT OUT 600 Ω 10 kΩ Lines - MONITOR OUT 600 Ω 10 kΩ Lines - REC OUT [L, R] 600 Ω 10 kΩ Lines - *1 0 dBu is referenced to 0.775 Vrms. 0 dBV is referenced to 1 Vrms. *2 Phone Jacks are unbalanced. Output Level Nominal Max. before Clip 125 W 500 W 75 W 300 W 50 W 220 W +4 dBu (1.23 V) +20 dBu (7.75 V) +4 dBu (1.23 V) +20 dBu (7.75 V) +4 dBu (1.23 V) +20 dBu (7.75 V) -10 dBV (316 mV) +10 dBV (3.16 V) Connector [A1, B1] SPEAKON [A2, B2] Phone Jack Phone Jack *2 Phone Jack *2 Phone Jack *2 RCA Pin Jack Specifications and descriptions in this owner's manual are for information purposes only. Yamaha Corp. reserves the right to change or modify products or specifications at any time without prior notice. Since specifications, equipment or options may not be the same in every locale, please check with your Yamaha dealer. EMX512SC/EMX312SC/EMX212S 33