Yamaha GO46 Owner's Manual - Page 12

Software Installation - Macintosh users Compatible operating systems The GO46 can only be used under Mac OS 10.3.6 (OS X) or higher. NOTE Refer to the system requirements printed on the package, or in the PDF manual page 25. You can also check the latest system requirements on the Internet. http://www.yamahasynth.com/ Installing the Control Panel The GO46 uses the operating system's CoreAudio and CoreMIDI drivers. Therefore, it is not necessary to install a device-specific driver. Simply plug the device into your IEEE1394 (FireWire) port using the included cable and the GO46 can be used immediately. However, to take full advantage of the advanced routing, sample rate switching, and other control features, please install the included Control Panel. 1. Insert the included "TOOLS for GO44/GO46" CD-ROM in the CD-ROM drive of your computer. 2. Double-click on the CD-ROM drive icon and open [GO46Driver_] → [GO46 Setup.pkg] to start the InstallShield Wizard. 3. The welcome message of the InstallShield Wizard appears. Click [Continue]. 4. Select the hard disk drive where the Mac OS is installed as the destination for the installation. Click [Continue]. 5. Click [Install] to start the installation. 6. Click [Restart] to complete the installation. NOTE For information about the Control Panel, see page 20 of the PDF manual. Assigning the GO46 as the default system audio device (Mac OS X) If you would like to use the GO46 not only for specific audio applications, but as your default Mac OS X audio device, select the GO46 audio driver in the [Sound] control panel as the default device for audio output. 12