Yamaha GO46 Owner's Manual - Page 14

Connectors and controls E [MASTER] knob Controls the levels of the analog outputs (OUTPUT 1/2 or OUTPUT 3/4). The output pair to be controlled can be selected via the Push function (OUTPUT 1/2 or OUTPUT 3/4 or both jacks). The output pair currently being controlled can be monitored by the MAIN/MONITOR LED. In addition, pressing and holding the knob for 2 seconds or more will mute the channels currently being controlled. This can be used to switch back and forth between two monitor speaker sets for a direct comparison. This function is also available via the GO46 Control Panel. (See page 20.) F MAIN and MONITOR LED Indicates the output pair currently being controlled by the master or muted. The MAIN LED corresponds to OUTPUT 1/2 jacks, MONITOR LED to OUTPUT 3/4. The following overview describes the operation and displays: MAIN LED MONITOR LED MASTER controls: Press and hold MASTER: On Off On Flashing Flashing Off On Flashing Off On On Off On Flashing Flashing Flashing OUTPUT 1/2 level OUTPUT 3/4 level OUTPUT 1/2, 3/4 level OUTPUT 1/2 level (OUTPUT 1/2 muted) OUTPUT 3/4 level (OUTPUT 1/2 remains muted) OUTPUT 3/4 level (OUTPUT 3/4 muted) OUTPUT 1/2 level (OUTPUT 3/4 remains muted) OUTPUT 1/2, 3/4 level (OUTPUT 1/2, 3/4 muted) OUTPUT 1/2 muted OUTPUT 3/4 muted OUTPUT 1/2, 3/4 muted OUTPUT 1/2 unmuted OUTPUT 1/2, 3/4 muted OUTPUT 3/4 unmuted OUTPUT 1/2, 3/4 muted OUTPUT 1/2, 3/4 unmuted G HEADPHONE LEVEL knob Adjusts the output level of the PHONES jack. H PHONES jack Output for a 1/4" stereo headphone jack. The signal from OUTPUT 3/4 on the rear panel is always available at the PHONES jack. The actual signal available there depends on the routing, which you can set up to suit your needs in the GO46 Control Panel. (See page 20.) 14