Yamaha HS80M Owner's Manual - Page 13
HS10W - used
UPC - 086792837536
View all Yamaha HS80M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
English HS10W INPUT R L " EXT SUB OUT % OUTPUT R L LOW CUT (Hz) ON OFF PHASE NORM. REV. HIGH LEVEL CUT (Hz) 100 100 0 10 80 120 80 120 # $ &' ( ) ! L INPUT R LOW CUT LOW CUT L OUTPUT R HIGH CUT PHASE EXT SUB OUT SUBWOOFER OFF POWER ON AC IN ! POWER switch Turns power to the speaker on or off. When the power is turned on the tuning fork mark on the front panel will light. " INPUT L/R connector These are balanced XLR-type and phone type input connectors. Two different signals can be input at these INPUT connectors. If two signals are input at the same time, they are mixed before being sent to the subwoofer. Do NOT use both the XLR and Phone type connector at the same time. Please connect to only one of these connectors. # EXT SUB OUT connector This is an XLR-type balanced output connector which outputs the mixed signal received by the INPUT L/R connectors. Use the EXT SUB OUT connector if you wish to add a second subwoofer. n The LOW CUT switch/control and HIGH CUT control do not affect the output level of the signal sent from the EXT SUB OUT connector. $ OUTPUT L/R jack These XLR-type balanced output connectors output the signals received at the INPUT L/R connectors, respectively. If the LOW CUT switch is on, the low frequency is cut. Use the LOW CUT control to set the cutoff frequency from 80 Hz to 120 Hz. * % LOW CUT switch If the LOW CUT switch is on, the low frequencies of the signal from the OUTPUT connector is cut. Use the LOW CUT control to set the cutoff frequency from 80 Hz to 120 Hz. & LOW CUT control Use the LOW CUT control to set the cutoff frequency from 80 Hz to 120 Hz when the LOW CUT switch is on. ' HIGH CUT control Use the HIGH CUT control to set the cutoff frequency of the signal output from the HS10W from 80 Hz to 120 Hz. ( LEVEL control Adjusts the overall output level. ) PHASE switch Selects a phase of output sound from the HS10W. You will usually set this switch to "NORM". However, the "REV." setting may improve low-range response, depending on the type and location of the entire speaker system. Try both settings and select the one that produces the best lowend sound. * AC IN Connector Connect the supplied power cable here. First connect the power cord to the subwoofer, then insert the power cord plug into the AC outlet. HS80M/HS50M/HS10W Owner's Manual 13