Yamaha HTR-5630 Owner's Manual - Page 55

Tuner, Remote control, English, ADDITIONAL, INFORMATION - problem

Get Yamaha HTR-5630 PDF manuals and user guides View all Yamaha HTR-5630 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 55 highlights

I Tuner TROUBLESHOOTING Problem Cause Remedy Refer to page FM stereo reception is The characteristics of FM stereo Check the antenna connections. 12 noisy. broadcasts may cause this problem Try using a high-quality directional FM when the transmitter is too far away or antenna. the antenna input is poor. Use the manual tuning method. 31 There is distortion, and There is multipath interference. Adjust the antenna position to eliminate - clear reception cannot multipath interference. FM be obtained even with a good FM antenna. The desired station cannot be tuned in with the automatic tuning method. The station is too weak. Use a high-quality directional FM antenna. - Use the manual tuning method. 31 Previously preset The unit has been disconnected for a Re-store the stations. 32 stations can no longer long period. be tuned in. The desired station cannot be tuned in with the automatic tuning method. The signal is weak or the antenna connections are loose. Tighten the AM loop antenna connections and - orient it for best reception. Use the manual tuning method. 31 There are continuous Noises result from lightning, Use an outdoor antenna and a ground wire. 12 AM crackling and hissing fluorescent lamps, motors, thermostats This will help somewhat, but it is difficult to noises. and other electrical equipment. eliminate all noise. There are buzzing and A TV set is being used nearby. Move this unit away from the TV. - whining noises (especially in the evening). I Remote control Problem Cause Remedy The remote control does Wrong distance or angle. not work nor function properly. The remote control will function within a maximum range of 6 m (20 feet) and no more than 30 degrees off-axis from the front panel. Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. Reposition this unit. The batteries are weak. Replace all batteries with new ones. The manufacture code has not correctly set. Set the code correctly. Try setting another code of the same manufacturer. Even if the manufacturer code is correctly set, there are some models that do not respond to the remote control. Refer to page 7 - 3 44 44 - ADDITIONAL INFORMATION English 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
51
English
ADDITIONAL
INFORMATION
■
Tuner
FM stereo reception is
noisy.
There is distortion, and
clear reception cannot
be obtained even with a
good FM antenna.
The desired station
cannot be tuned in with
the automatic tuning
method.
Previously preset
stations can no longer
be tuned in.
The desired station
cannot be tuned in with
the automatic tuning
method.
There are continuous
crackling and hissing
noises.
There are buzzing and
whining noises
(especially in the
evening).
Problem
FM
AM
Cause
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
There is multipath interference.
The station is too weak.
The unit has been disconnected for a
long period.
The signal is weak or the antenna
connections are loose.
Noises result from lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
A TV set is being used nearby.
Remedy
Check the antenna connections.
Try using a high-quality directional FM
antenna.
Use the manual tuning method.
Adjust the antenna position to eliminate
multipath interference.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Re-store the stations.
Tighten the AM loop antenna connections and
orient it for best reception.
Use the manual tuning method.
Use an outdoor antenna and a ground wire.
This will help somewhat, but it is difficult to
eliminate all noise.
Move this unit away from the TV.
Refer to
page
12
31
–
–
31
32
–
31
12
–
■
Remote control
Problem
The remote control does
not work nor function
properly.
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The manufacture code has not correctly
set.
Even if the manufacturer code is correctly
set, there are some models that do not
respond to the remote control.
Remedy
The remote control will function within a
maximum range of 6 m (20 feet) and no more
than 30 degrees off-axis from the front panel.
Reposition this unit.
Replace all batteries with new ones.
Set the code correctly.
Try setting another code of the same manufac-
turer.
Refer to
page
7
–
3
44
44
–
TROUBLESHOOTING