Yamaha HTR 5830 MCXSP10 Manual - Page 13

PREPARATION CONNECTIONS Before connecting components CAUTION Do not connect this unit or other components to the mains power until all connections between the components have been completed. • Be sure to connect the left channel (L), right channel (R), "+" (red) and "-" (black) properly. Some components require different connection methods and have different jack names. Refer to the operation instructions for each component you wish to connect to this unit. • After you have completed all connections, check them again to make sure they are correct. • The jack names correspond to the names on the input selector. ■ Connecting to digital jacks This unit has digital jacks for direct transmission of digital signals through either a coaxial or fiber optic cable. You can use the digital jacks to input PCM, Dolby Digital and DTS bitstreams. Use digital connections if you wish to enjoy the multi-channel sound track of DVD material, etc. with DSP effects. Both digital input jacks are acceptable for 96 kHz sampling digital signals. Note • The OPTICAL jack on this unit conform to the EIA standard. If you use a fiber optic cable that does not conform to EIA standard, this unit may not function properly. Signal flow inside this unit COMPONENT VIDEO Input VIDEO Output (MONITOR OUT) DIGITAL INPUT jacks (pages 9 - 12) 6CH INPUT jacks (page 13) Video component jacks (page 10) COMPONENT VIDEO jacks (page 11) Speaker terminals (page 16) 6CH INPUT FRONT AUDIO R L VIDEO DVD TUNER DIGITAL INPUT CD 3 SURROUND SUB WOOFER COAXIAL OPTICAL DTV /CBL 2 DVD 1 CD IN (PLAY) MD /CD-R OUT (REC) R CENTER L DTV /CBL V-AUX IN VCR OUT SUB WOOFER AM ANT GND FM ANT 75Ω UNBAL. MONITOR OUT AUDIO OUTPUT COMPONENT VIDEO Y PB PR MONITOR OUT DVD DTV /CBL A R FRONT L SPEAKERS SURROUND R L CLASS 2 WIRING B FRONT R L CENTER Audio component jacks (page 12) SUBWOOFER OUTPUT jack (page 16) Antenna input terminals (page 13) This jack is reserved for factory use. Do not connect any equipment to this jack. 9