Yamaha HTR 5830 MCXSP10 Manual - Page 58
Problem, Cause, Remedy, Refer to, CHECK SP WIRES - troubleshooting
UPC - 027108921679
View all Yamaha HTR 5830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
TROUBLESHOOTING Problem Cause Remedy Refer to page No sound from the The output level of the center speaker is Raise the level of the center speaker. 50 center speaker. set to minimum. "SOUND 1A CENTER" on the set menu Select the appropriate mode for your center speaker. 41 is set to NONE. One of the HiFi DSP programs (1 to 4) Select another sound field program. has been selected (except for 5ch Stereo). 27 - 32 The source encoded with a Dolby Digital - or DTS signal does not have a center channel signal. No sound from the The output level of the surround speakers Raise the output level of the surround speakers. 50 surround speakers. is set to minimum. A monaural source is being played with program 9. Select another sound field program. 27 - 32 No sound from the "SOUND 1D BASS" on the set menu is Select SWFR or BOTH. 42 subwoofer. set to FRNT when a Dolby Digital or DTS signal is being played. "SOUND 1D BASS" on the set menu is Select BOTH. 42 set to SWFR or FRNT when a 2-channel source is being played. The source does not contain low bass - signals (90 Hz and below). Poor bass "SOUND 1D BASS" on the set menu is Select FRNT. 42 reproduction. set to SWFR or BOTH and your system does not include a subwoofer. The speaker mode settings (front, center or surround) on the set menu does not match your speaker configuration. Select the appropriate position for each speaker based 41 - 42 on the size of the speakers in your configuration. A "humming" sound can be heard. Incorrect cable connections. Firmly connect the audio plugs. If the problem - persists, the cables may be defective. The volume level The component connected to the OUT Turn on the power to the component. - cannot be increased, (REC) jacks of this unit is turned off. or the sound is distorted. The sound effect It is not possible to record the sound - cannot be recorded. effect with a recording component. The sound field "OPTION 2 MEM. GUARD" in the SET Select OFF. - parameters and some MENU is set to ON. other settings on the unit cannot be changed. The unit does not The internal microcomputer has been Disconnect the AC power cord from the outlet and - operate properly. frozen by an external electric shock (such then plug it in again after about 30 seconds. as lightning or excessive static electricity) or by a power supply with low voltage. "CHECK SP WIRES" The speaker cables are short circuited. Make sure all speaker cables are connected correctly. - appears on the front panel display. 54