Yamaha HTR 6060 MCXSP10 Manual - Page 29
Setting the speaker impedance, Turning this unit on and off, Turning on this unit, Press
View all Yamaha HTR 6060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
PREPARATION Connections Setting the speaker impedance Caution If you are to use 6 ohm speakers, set "SP IMP." to "6Ω MIN" as follows BEFORE using this unit. 4 ohm speakers can be also used as the front speakers. 1 Make sure this unit is turned off. Refer to the right column for details. 2 Press and hold BTONE CONTROL on the front panel and then press ASTANDBY/ON to turn on this unit. This unit turns on, and the advanced setup menu appears in the front panel display. TONE CONTROL While holding down STANDBY /ON 3 Rotate the CPROGRAM selector on the front panel to select "SP IMP.". "SP IMP." and the current speaker impedance setting ("8Ω MIN") appear in the front panel display. Turning this unit on and off ■ Turning on this unit Press ASTANDBY/ON on the front panel to turn on this unit. When you turns on this unit by pressing ASTANDBY/ ON, this unit is turned on. y When you turn on this unit, there will be a 4 to 5-second delay before this unit can reproduce sound. ■ Set this unit to the standby mode Press ASTANDBY/ON (or GSTANDBY) to set this unit to the standby mode. In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control. y • You can also turn on this unit by pressing ESCENE (or FSCENE) buttons. • When you turn on this unit, there will be a 4 to 5-second delay before this unit can reproduce sound. 4 Press BTONE CONTROL on the front panel repeatedly to select "6Ω MIN". 5 Press ASTANDBY/ON on the front panel to save the new setting and turn off this unit. Note The setting you made is reflected next time you turn on this unit. English 25 En