Yamaha IM8-24 Owner's Manual - Page 15

English Controls and Functions 4 MONO Control This control adjusts the level of the signal sent from MONO OUT to the MATRIX OUT jacks. 5 MATRIX master Control This control adjusts the overall level of the signal output to the MATRIX OUT jacks. The "▼" position of the knob is nominal level (0 dB). 6 AFL Switch/Indicator When the AFL switch is on, the indicator will light and the signal after the MATRIX master control is output to the PHONES and MONITOR OUT jacks for monitoring. NOTE · If you want to monitor the signal after the MATRIX master control, turn off all PFL switches. DC POWER INPUT Section Rear Panel NPUT Top Panel 1 2 1 DC POWER INPUT Connector Connects the Yamaha Power Supply PW8 to the console using the included power supply cable. • Turn off the Yamaha PW8 power supply before you connect or disconnect the power supply cable to or from the console. • To prevent loud pops and noises, turn on the power to your equipment in the following order; first the audio sources, then the PW8, and finally the power amplifiers. Reverse this order when turning the power off. 2 POWER Indicator This will light when the Yamaha PW8 power supply is connected to the console and the PW8 is turned on. MUTE MASTER Section Top Panel TALKBACK Section Rear Panel Top Panel 1 2 3 4 1 TALKBACK MIC IN Jack This is an XLR-3-31 type unbalanced input jack for connecting a talkback microphone. 2 Bus Assign Switches These determine the output destination of the signal from the TALKBACK MIC jack. • AUX 1-2, 3-4, 5-6, 7-8 switches: Send the signal to the AUX 1/2-7/8 buses. • GROUP 1-8 switch: Sends the signal to the GROUP 1-8 buses. • STEREO/MONO switch: Sends the signal to the ST L/R and MONO buses. • MATRIX 1-2, 3-4 switches: Send the signal to the MATRIX 1/2 or 3/4 buses. 3 TALKBACK LEVEL Control Adjusts the level of the signal received from the TALKBACK MIC jack. 4 ON Switch/Indicator When you turn this switch on, the indicator will flash and the talkback function will be enabled. 1 1 MUTE Master Switches/Indicators (1-4) These switches toggle input channel muting on and off. Turning a switch (1-4) on will mute the input channels whose MUTE switch (page 10) of the corresponding number is turned on. When the signal is muted, the ON indicator of the input channels will go dark. Owner's Manual 15