Yamaha MCS-1330 Owner's Manual - Page 13
Connecting The External Components With The System - australia
View all Yamaha MCS-1330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
CONNECTING THE EXTERNAL COMPONENTS WITH THE SYSTEM CONNECTING THE EXTERNAL COMPONENTS WITH THE SYSTEM Make sure you read the following procedure and notes carefully before connecting the system. For information on the speakers (NS-BP400), refer to the owner's manual supplied with it. CAUTION • Do not connect this unit or other components to the main power until all connections between components are complete. • Do not let the bare speaker wires touch each other or do not them touch any metal part of the receiver. This could damage the receiver and/or the speakers. • All connections must be correct: L (left) to L, R (right) to R, "+" to "+" and "-" to "-". If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. Also, refer to the owner's manual for each of your components. Turntable DVD player etc. Subwoofer Right speaker (NS-BP400) GND Left speaker (NS-BP400) Audio out RCA L R stereo cable Audio out RCA L R stereo cable INPUT INPUT PREPARATION R L SPEAKERS:6 MIN. GND ANTENNA L INPUT R PHONO 75 UNBAL. FM GND AM OUTPUT SUB WOOFER SYSTEM CONNECTOR CD AUX TO:CD PLAYER Receiver (R-1330) System control cable (supplied) 5 4 3L OUTPUT R L TO:RECEIVER SYSTEM CONNECTOR RCA stereo cable (supplied) 12 CD player (CD-1330) Connecting the system Connect the CD (L/R) jacks of the receiver to the OUTPUT (L/R) jacks of the CD player using the supplied audio RCA stereo cable. Connect the SYSTEM CONNECTOR (TO:CD PLAYER) jack of the receiver to the SYSTEM CONNECTOR (TO:RECEIVER) jack of the CD player using the supplied system control cable. Connect the speaker terminals (L) of the receiver to the speaker terminals of the left speaker and the speaker terminals (R) of the receiver to the speaker terminals of the right speaker using the speaker cables supplied with the speaker set (NSBP400). Also, attach the clamp filter to the speaker cables within 10 cm of the left and right speaker terminals (see page 2). Notes • The NS-BP400 speakers are not magnetically shielded, so place the speakers away from the monitor. When connecting speakers other than NS-BP400, use the speakers having more than 6 Ω impedance. • The PHONO jacks are only compatible with a turntable with MM cartridge. • Connect your turntable to the GND terminal to reduce noise in the signal. However, you may hear less noise without the connection to the GND terminal for some turntable(s). When using banana plugs (commercially available), tighten the speaker terminals strongly then connect the banana plugs (for U.S.A, Canada, Australia and China models). 9 En English